What is the bandwidth of the fm signal

Reference no: EM131278119

1. A carrier waveform c(t) = 100cos(2π10⁸t) is frequency modulated by the message tone m(t) = 10cos(2π10⁴t).

The maximum frequency deviation is 20 kHz. Find the following:

a) The amplitude and the frequency of all signal components that have power level of at least 15% of the power of the FM signal.

b) What is the bandwidth of the FM signal?

2. Starting with the equation shown below for a SSB modulated wave, find the output produced by the coherent detector shown in the figure in response to this modulated wave. Simplify and state the bandwidth of the low-pass filter. Discuss the impact on the output of the local oscillator reference phase shift Φ.

3. Consider a system of the type shown below. Let the input signal be

x(t) = 2cos (10πt) + cos(20πt).

Sketch the spectrum of the signal at every point in the system.

4. An AM transmission system with modulation percentage 20% has a message signal of the form m(t) = 4cos(t) applied to it.

a) What are the minimum and maximum voltage levels of the envelope?

b) How much power is used on the carrier? How much power is used for the message (the sidebands)?

c) We would like to use an envelope detector to demodulate this signal. Will the signal be distorted? What are two things that we can do to reduce distortion.

Reference no: EM131278119

Questions Cloud

Discuss about the curriculum for california police officers : LEA339,LEA316,Discuss about the Curriculum for California police officers

Determine the overall thermal efficiency of this combined : The steam-condenser pressure is 5 psia and the isentropic efficiency of the steam turbine is 95 percent. Determine the overall thermal efficiency of this combined cycle. For air, use constant specific heats at room temperature.

Describing a closed economywith no government : Consider the following information describing a closed economywith no government:

Find the fraction of steam extracted for process heating : Consider a cogeneration power plant that is modified with reheat and that produces 3 MW of power and supplies 7 MW of process heat

What is the bandwidth of the fm signal : The amplitude and the frequency of all signal components that have power level of at least 15% of the power of the FM signal and what is the bandwidth of the FM signal?

How technology might also affect the process : How these techniques might be applied or modified in a health care work environment? How technology might also affect this process?

Determine the utilization factor of the plant : A textile plant requires 4 kg/s of saturated steam at 2 MPa, which is extracted from the turbine of a cogeneration plant. Steam enters the turbine at 8 MPa and 500°C at a rate of 11 kg/s and leaves at 20 kPa

Competitive market equilibrium : If stores act independently, what is the competitive market equilibrium? How many guards each store will hire? Show the results mathematically.

What would these evaluation criteria tell you about : What would these evaluation criteria tell you about the pprevious and current sales rep? List and describe five pipeline analysis evaluation criteria that would have allowed you.

User Account

All Pages