What is the approximate present worth of the pipe

Assignment Help Civil Engineering
Reference no: EM13319273

An oil company is planning to install a new pipeline to connect storage tanks to a proccessing plant 1500m away . Both 120 mm and 180 mm pipes are being considered.

120 mm pipe 180 mm pipe
Initial cost $2500 $3500
Service life 12 years 12 years
Salvage value $ 300 $ 400
Annual maint. $ 300 $ 200
Pump cost/hr. $1.40 $1.00
Pump operation 600 hr./yr. 600 hr./yr

The company will use an annual interest rate of 10%. Annual maintenance and pumping costs may be considered to be paid in their entireties at the end of the years in which their costs are incurred.

What is the approximate present worth of the 120 mm pipe over the first 12 years of operation?
A. 9200
B. 10,200
C. 11,900
D. 12,100


What is the present worth of the 180 mm pipe over the first 12 years of operation if operating costs increased by %0.75 ( to 1.75 per hour) beginning in year 7?
A. 8790
B. 9010
C. 9380
D. 9930

Reference no: EM13319273

Questions Cloud

Show the effect of an increase in the minimum wage : Using a diagram of the labor market, show the effect of an increase in the minimum wage on the wage paid to workers, the number of workers supplied, the number of workers demanded, and the amount of unemployment.
What percentage removal should be expected for particles : What percentage removal should be expected for each of the following particle settling velocities in an ideal sedimentation tank: 0.1 mm/s, 0.2 mm/s, 1 mm/s.
Estimate the combined amounts of water evaporated : An 8000 mile^2 watershed received 20 in. of precipitation in a 1 year period. The annual stream flow was recorded as 5000 cfs. Roughly estimate the combined amounts of water evaporated and transpired.
Relationship between npv and a firms value : Explain the relationship between NPV and a firm's value and why might the relationship not behave as expected - explain why NPV is generally preferred over IRR when choosing among competing (mutually exclusive) projects.
What is the approximate present worth of the pipe : An oil company is planning to install a new pipeline to connect storage tanks to a proccessing plant 1500m away . Both 120 mm and 180 mm pipes are being considered.
Suppose households believe that greater government borrowing : Suppose households believe that greater government borrowing today implies higher taxes to pay off the government debt in the future. What does this belief do to private saving and the supply of loanable funds today?
Describe motivations for leasing : Determine whether Renew should lease or purchase the machine if its before-tax cost of borrowing is 8% and briefly describe three motivations for leasing.
By how much does the spring stretch : In 0.675 s, a 6.80-kg block is pulled through a distance of 4.10 m on a frictionless horizontal surface, starting from rest. By how much does the spring stretch
Draw the influence line for the shear in panel cd of girnder : Draw the influence line for the shear in panel CD of the girder. Determine the maximum negative live shear in panel CD due to a uniform live load of 500 lb/ft action on the top beams.

Reviews

Write a Review

Civil Engineering Questions & Answers

  How is raw pig iron extracted from iron oxide ores

(a) How is raw pig iron extracted from iron oxide ores (b) Write a typical chemical reaction for the reduction of iron oxide (Fe2O3) by carbon monoxide to produce iron.

  With what velocity will air enter room under laboratory door

Laboratories containing dangerous materials are often kept at a pressure slightly less than ambient pressure so that contaminants can be discharged through an exhaust system rather than leaked through cracks and around doors to other parts of the ..

  Determine what is the most probable length

a line was measured five times, the readings were: 100.08, 100.51, 100.32, 100.16, 100.22. what is the error. What is the most probable length.

  Determine the mass flow raw through the nozzle

Air enters an adiabatic nozzle steadily at 300 kPa, 200?C, and 30 m/s and leaves at 100 kPa and 180 m/s. The inlet area of the nozzle is 80 cm2. Determine (a) the mass flow raw through the nozzle, (b) the exit temperature of the air, and (c) the e..

  Which alternative should be selected at the interest rate

The cash flow of alternatives J and K is shown below. If the interest rate is 10% per year, which alternative should be selected. Perform a Present Worth analysis.

  What will be the approximate temperature of the alloy

Is it possible to have a copper-silver alloy of composition 50 wt% Ag-50 wt% Cu that at equilibrium, consists of α and β phases having mass fractions Wα = 0.60 and Wβ=0.40

  Determine the downstream water level to produce the flowrate

The flow through an 8 ft. Parshall Flume is 129 cfs when Ha is 2.50 ft. Determine the downstream water level (Hb) that would produce this flowrate.

  What is the market value of the plants electricity annually

Biomass is increasingly used as a fuel to produce power and heat. A sugarcane-­? processing mill is powered by a biomass power plant with 140 MW of electricity and with 60 MW of heat in the form of steam for sugar extraction from the cane.

  Determine how many molecules of h20 is the system

A piston cylinder contains 0.8kg of steam (water vapor) at 300 deg C and 1MPa absolute. The steam is cooled at constant pressure until half of the mass condenses.

  Change in it internal energy

A gas is compressed at a constant pressure of 0.800 atm from 9.00L tp 2.00L. in the process, 400J of energy leave the gas by heat. (a) What is the work done on the gas? (b) What is the change in it internal energy?

  Determine the detention time of the first pond

Three completely mixed stabilization ponds are connected in series, and the system removes 99.998% from the total coliform count of the influent to the first pond. In stabilization ponds, coliform bacteria are removed by a first-order process

  Falling-head permeability test

A falling-head permeability test was carried out on a clay soil of diameter 100 mm and length 150 mm. In 4 minutes the head in the standpipe of diameter 5mm dropped from 680 to 350 mm.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd