What is the amount of work required to stretch linear spring

Assignment Help Mechanical Engineering

Reference no: EM13709605

1. What is the amount of work required to stretch a linear spring from its rest position by an amount of 0.20m if it has a spring constant of 45 kN/m.

2. A water pump increases the water pressure from 15 psia to 55 psia. Determine the power input required, in hp, to pump 0.80 ft^3/s of water.

3. A geothermal pump is used to pump brine with a density of 1050 kg/m^3 at a rate of 0.30 m^3/s from a depth of 200 m. For a pump efficiency of 74% determine the required power input to the pump. Neglect any frictional losses in the pipes and assume the geothermal water at 200m depth to be exposed to the atmosphere.

Reference no: EM13709605

Questions Cloud

Surface concentration during diffusion : For diffusion of Cu into Al at 1000 K for 10 hours, calculate the distance into the material at which the concentration of Cu will be 5% if the initial concentration of Cu in the Aluminium was 0.5% and the surface concentration during diffusion was 5..

Determine the change in pressure between these two locations : At a certain position in a piping system, a fluid with a specific gravity of 1.50 passes through an 8-cm diameter pipe with a velocity of 1.2 m/s. At some point downstream the elevation of the pipe has increased by 15 m and the pipe size has been red..

Determine the mass flow rate of air through the turbine : An adiabatic gas turbine expands air at 1,000kPa and 500C to 100kPa and 150C. Air enters the turbine through 0.200m^2 opening with an average velocity of 40 m/s and exhausts through a 0.910m^2 opening.

The diffusivity of copper in a commercial brass alloy : The diffusivity of copper in a commercial brass alloy is 10^-20 m2/s at 500'C. The activation energy for diffusion of copper in this system is 195 kJ/mol. Calculate the diffusivity at 600'C.

What is the amount of work required to stretch linear spring : What is the amount of work required to stretch a linear spring from its rest position by an amount of 0.20m if it has a spring constant of 45 kN/m. A water pump increases the water pressure from 15 psia to 55 psia. Determine the power input required,..

What is his total kinetic energy in units of btu : A skydiver with mass of 175 pounds is falling at a velocity of 50.0 meters per second. What is his total kinetic energy in units of Btu? Determine the amount of energy required to accelerate a 1225 kg car from 10.0 to 60.0 km/h on an uphill road with..

Administer fluids and drugs rapidly : Physicians often use IV lines to administer fluids and drugs rapidly. The rate of application of the IV fluid is determined to some extent by the height of the IV bag above the patient. Assume that the IV line enters the patient through her venous sy..

Typical towns in states with big plains like texas : Typical towns in states with big plains like Texas need an elevated tank to supply tap water. Below there is a picture of a typical elevated tank. If we approximate the tank as a cylinder with a diameter of 50 ft and a height of 25 ft, answer the fol..

Calculate the heat transfer per unit mass of water : Water enters a boiler at 160 psia as a saturated liquid and leaves at 600 degree F at the same pressure. Calculate the heat transfer per unit mass of water.

User Account

All Pages