Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Using a 3-V power supply, design a version of the circuit of fig 6.62 from the book. to provide a dc emitter current of 0.5 mA and to allow a +-1-V signal swing at the collector. The BJT has a nominal B=100. Use standard 5 % resistor values. if the actual BJT used has b=50, what emitter current is obtained? also, what is the allowable signal swing at the collector? Repeat for B=50. can u answer this question as soon as possible?
A control system is needed to control a small shopping center parking lot lighting system and the exterior lighting for the building. The design specifications require that the parking lot lighting and the exterior lighting turn on at dusk automat..
MOS (p and n) npn and pnp transistors with parameters given in the text or select your own by using industrial data sheets, available on the internet. Also resistors, capacitors, and power supplies (10 V, 5 V, and 3.3 V) are available.
The generator is delivering 48 MW to the bus bar at the rated voltage with its field current adjusted for a generated emf of 46 kV per phase. Determine the armature current and the power factor. State whether power factor is lagging or leading
A silicon semiconductor resistor is in the shape of a rectangular bar with a cross sectional area of 1x10^-6 cm^2 a length of 0.1 cm and is doped with a donor concentration of 5x10^16 cm^-3.
A message signal, x(t) has a bandwidth of 15 kHz and an average power of 0.5 W. This signal is to be uniformly quantized with an input range of range of +-5 V. What is the bit rate of the corresponding PCM signal if the SQNR is to be greater than ..
write an 8051 program that would generate a 200khz, 50% duty cycle, square wave at P1.0.Use Timer 0 for the delay. Ignore the overheads cycles due to the instructions in the loop. Assume 12 MHz clock. All data must be hex.
Finding values of a composite discrete time signal, A discrete time signal x(n) = x(n-1) + x(n-3) with initial conditions x(0) = 0, x(1) = 1 and x(2) = 2 is examined and the first 51
Consider a uniform electric field of 50 N/C directed toward the east. If the voltage measured relative to ground at a given point is 80 V, what is the voltage at a point 1.0 m directly west of that point
Increasing the number of SIMD processors to 15 (assume this change doesn't affect any other performance metrics and that the code scales to the additional processors)
A ball of radius 1 meter centered at the origin has uniformly distributed over its volume a positive charge Q. a. In moving a positive test charge from the point (x, y, z)= (2, 2, 2) to the point (4, 4, 4), do you have to do work on the test charge..
Two strands of infinitely long current rights carry currents of equal magnitude. Find the magnetic field produced by the two filaments at the midpoint between the two strands. Compare this result if the currents: a) have the same direction
A tree-phase, 60Hz, 5MVA synchronous generator has balanced line-to-line voltages of 8320V at its terminals. if the generator is supplying power to delta-connected, balanced load of 5MVA at a 0.8 lagging power factor
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd