What is the alkalinity of this water expressed as mg/l

Assignment Help Civil Engineering
Reference no: EM13555171

1.A 2m^3 of block is placed in oil (SG = 0.8) and displaces 1.5m^3 of the oil. Calculate the weight, mass and specific gravity of the block

2.determine the moment of the force f about an axis extending between A and C. Express the result as a cartesian vector. A is at the origin, C is at (4,3,0) and F = (4i + 12j -3k) lb coming out of B (4,3,-2).

3.A water sample contains 118mg/L of bicarbonate ion, 19mg/L of carbonate ion, and has a pH of 9.5. What is the alkalinity of this water expressed as mg/L of CaCO3?

4.The Jordan aquifer has been pumped for several decades, yet remains fully saturated. Explain where the water is coming from

Reference no: EM13555171

Questions Cloud

How can you increase the performance of the least efficient : There are three reactors degrading a chemical biologically, at three degradation rates; i.e., 0.2 d^-1, 0.4 d^-1, and 1.0 d^-1. The residence time of the chemical in these reactors are 10 d, 5 d, and 55 d, respectively
Determine the magnitude of its acceleration at this instant : Car traveling along a circular curve that has a radius of 50m. if its speed is 16m/s and is increasing uniformly at 8 m/s^2 determine the magnitude of its acceleration at this instant.
Determine the maximum water table elevation : A canal was constructed running parallel to a river 1500 ft away. Both fully penetrate a sand aquifer with a hydraulic conductivity of 1.2 ft/d. The area is subject to rainfall of 1.8 ft/y and evaporation of 1.3 ft/y. The elevation of water above the..
What is the discharge rate per unit width of the aquifer to : To avoid the salinization of soil in a farming area, parallel drainage canals are to be installed to maintain the water table at a depth of at least 4m below the ground surface. It is thought that no evapo-transpiration would occur below that depth.
What is the alkalinity of this water expressed as mg/l : A water sample contains 118mg/L of bicarbonate ion, 19mg/L of carbonate ion, and has a pH of 9.5. What is the alkalinity of this water expressed as mg/L of CaCO3?
What is a chance that a driver who has a positive breathalyz : A police officer stops a speeding driver on saturday nigt and gives hima breathalzer test. the test shows that his estimated blood alcohol content is above .08 g/dl, and this is considered evidence of driving while intoxicated
Do you think the gravel will be scoured by the flowing water : The bottom is a 6 in slab of rough concrete. If the water is flowing at a uniform depth of 6 ft, do you think the gravel will be scoured by the flowing water
Determine the force exerted on th mass in the direction : A 150 kg mass is suspended by wires from two hooks. the lengths of the wires have been adjusted so that the wires are each 50º from horizontal. assume that the mass of the wires is negligible.
Calculate the normal force n exerted by the side of the slot : The flat circular disk rotates about a vertical axis through O with a slowly increasing angular velocity ?. Prior to rotation, each of the 0.60-kg sliding blocks has the position x = 29 mm with no force in its attached spring. Each spring has a stiff..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Which beam has the largest maximum moment

Consider two beams, which are loaded the same but have different support conditions. Which beam has the largest maximum moment? First, find support reactions, and then plot axial force (N), shear (V)

  Derive equation that would allow for the direct calculation

A completely mixed flow reactor, with a volume of V and a flow rate of Q, has a zero-order reaction, dA/dt = k, where A is the material being produced and k is the rate constant.

  Find the value of the angle at which the projectile is fired

A projectile is fired with an initial velocity of 800 ft/s at a target B located 2000 feet above the gun A and at a horizontal distance of 12,000 feet. Neglecting air resistance, determine the value of the angle at which the projectile is fired.

  Determine what is the surface tension of the liquid

Outside diameter is 10 cm and inner diameter is 9.5cm. The Mass of the ring is 16g. The force required is the weight corresponding to a mass of 16g. What's the surface tension of the liquid

  Calculate the weight percent of hno3 in the solution

Commercial aqueous nitric acid, HNO3, has a density of 1.42 g/mL and is 16 M. Calculate the weight percent of HNO3 in the solution.

  Determine the daily discharge of groundwater into the canal

A canal is constructed parallel to a river 600 m away both fully penetrating an unconfined aquifer of coarse sand and fine gravel as shown in the illustration below. The aquifer is subject to an average infiltration of 2.3 m/year

  Determine my daughters angular velocity about central axis

Imagine a slide with a radius of 1.5 m and a vertical drop of 2 m per turn. Further suppose that one of my daughters is sliding down at a constant speed of 2 m/s

  Calculate the concentration of copper through the plate

A plate of aluminum is exposed to an atmosphere of Copper hydride,and on the other side of the plate, an atmospere that is deficientin copper hydride. If a steady state condition is achieved

  Find the capacity of the column with 1% reingforcement

A circulatr concrete column with a diameter of 8" has spiral reinforcing. Find the capacity of the column with 1% reingforcement. Find the capacity of the column with 8% reinforcement.

  Explain how to estimate the amount of rainfall for gauge x

The rain¬fall amounts at three adjacent stations A, B, and C were 4.2, 3.7, and 4.9 in., respectively. The average annual precipitation amounts for the gauges are X = 36.5, A = 42.1, B = 37.1, and C = 39.8 inches.

  Determine the total volume of the sandy silt

A 200,000 cubic m highway embankment is to be constructed at dry density of 1.85 Mg/m^3 and optimum moisture content of 16% by compacting sandy silt taken from a borrow pit. The in-situ bulk density of the sandy silt is 1.92 Mg/m^3 and its average wa..

  Calculate the corrected distance to the right of line ab

When measuring a distance AB, the first taping pin was placed 1.5ft to the right of line AB and the second pin was set 1.5 ft left of line AB. The recorded distance was 236.89 ft. ( Assume 3 taped segments, the first two 100 ft each.)

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd