What is tension in swing cable developed during the motion

Assignment Help Mechanical Engineering
Reference no: EM13701072

A gentry structure, similar to a tire swing, is used to test the response of an airplane is hoisted back until the 20m swing cable is at theta=60. Determine the speed of the plane just before crashing into the ground at theta=15, when released from rest. Also what is the tension in the swing cable developed during the motion? Ignore wing lift.

Reference no: EM13701072

Questions Cloud

Calculate the average temperature of the plate surface : Air at atmospheric pressure and a temperature of 25°C is in parallel flow at a velocity of 5 m/s over a 1m long flat plate that is heated with a uniform heat flux of 1250 W/m2. Assume the flow is fully turbulent over the length of the plate.
Fluid is ethylene glycol under the same flow conditions : For a laminar boundary layer flow over a flat plate with air at 20°C and 1atm, the thermal boundary layer thickness Dt is approximately 13% larger than the velocity boundary layer thickness D. Determine the ratio D/Dt if the fluid is ethylene glycol ..
Piston cylinder device contains : A piston cylinder device contains .733 kg of refrigerant-134a at -10 degrees C. The piston that is free to move has a mass of 8.63 kg and a diameter of 21.2 cm. The local atmospheric pessure is 88 kPa. Now, heat is transferred to the refridgerant-134..
How many times can he jump on his bed before beam breaks : After one particularly wild night at the bars, Jon decides to come home and jump on his bed .Assume that he's jumping directly in between one steel support beam that's 10 foot long, 2 inches wide and 1 inch thick. Further assume that Jon weighs aroun..
What is tension in swing cable developed during the motion : A gentry structure, similar to a tire swing, is used to test the response of an airplane is hoisted back until the 20m swing cable is at theta=60. Determine the speed of the plane just before crashing into the ground at theta=15, when released from r..
Determine the maximum power supplied by the engine : A sports car has a mass of 2000 kg and an engine running at an efficiency of 0.63, as it moves forward with a constant velocity of v=50 m/s,the wind creates a drag resistance on the car of FD=1.2v^ newtons. Determine the maximum power supplied by the..
Coefficient of kinetic friction between the wheels and road : A 3500 Ib. automobile is traveling down a 10 incline a 20 ft/./s. if the driver slams the break, causing the wheels to lock , determine how far the tires slide. the coefficient of kinetic friction between the wheels and the road is uk=0.5
Calculate adiabatic flame temperature butane burning : Calculate adiabatic flame temperature butane (C4H10) burning in air at 298 k and 1 atm, assuming complete combustion and constant specific heats.
An ideal refrigeration cycle : An ideal Refrigeration cycle with R134a as the working fluid consists of isentropic compression from saturated vapor at -10 C, constant-pressure heat rejection in the condenser5 at 39 C, constant- enthalpy pressure loss across a throttle valve, and c..

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Q1 figure shows a scale drawing of the temperature profile

q1 figure shows a scale drawing of the temperature profile through a composite plane wall.i identify the layer with the

  Knowing that the cylinder rolls without sliding on the

a 12-in radius cylinder of weight 16-lb. rests on a 6 lb carriage. the system is at rest when a force p of magnitude

  Discuss the factors beyond crystal structure

Discuss the factors beyond crystal structure, quenching and temperature that affect he results of a specimen in a Charpy V notch impact testing.

  The steam enters at 360 degc with a velocity of 35 ms and

25 mw power is produced in a well-insulated steam turbine operating at steady state. the flow rate of steam through the

  Determine the natural frequency of vibration

the lower end of the 30 kg slender rod is displaced a small amount and released from the rest. determine the natural frequency of vibration. the springs have stiffness of 500 N/m and they are stretched when the rod is hanging vertically.

  Determine the size of the contact patch and the maximum

determine the size of the contact patch and the maximum contact stresses for a 40-mm-dia steel cylinder 25 cm long

  Alson in moving from point a in a particular circuit to

in moving from point b in a particular circuit to point a an electron gains 4 aj of potential energy. what is the

  A system consisting of 3 lb of water vapor in a piston-

a system consisting of 3 lb of water vapor in a piston- cylinder assembly initially at 350degf and a volume of 71.7 ft3

  If the liquid water is initially at a temperature of 30degc

a pot of 1 kg of liquid water is heated on a mountain top where the atmospheric pressure is 0.8 bar. if the liquid

  A carnot heat engine using 1 kg of air has the following

a carnot heat engine using 1 kg of air has the following conditions heat addition beginning at 15 mpa and 1200 k and

  Determine the mass flow rate of spray water and the power

an industrial process requires an atmosphere having a rh of 88.4 at 22 degree c and involves a flow rate of 2000 m3h.

  Find the equation of motion and the natural frequency

Three springs and a mass are attached to a rigid, weightless bar PQ. Find the equation of motion and the natural frequency of vibration of the system.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd