What is shear rate in water in sliding and standing plates

Assignment Help Civil Engineering
Reference no: EM13320644

What is the shear rate in the water between a sliding and standing plate, if V = 10 ft/s is the moving plate velocity and 0.1 in. is the distance between the plates? How much force is acting upon each in.^2 of either of the plates by the water?

Reference no: EM13320644

Questions Cloud

Find the amplitude of the resultant wave : Two waves are traveling in the same direction along a stretched string. The waves are 45.0° out of phase. Find the amplitude of the resultant wave
What are the values of its density and specific volume : A certain gas weighs 16.0 N/m3 at a certain temperature and pressure. What are the values of its density, specific volume, and specific gravity relative to air weighing 12.0 N/m3
Testing worries boosts exam performance : Writing about testing worries boosts exam performance in the classroom
What angle will the cable finally make with the vertical : A crate of mass 2000 kg is hanging from a crane at the end of a cable 12 m long. what angle will the cable finally make with the vertical
What is shear rate in water in sliding and standing plates : What is the shear rate in the water between a sliding and standing plate, if V = 10 ft/s is the moving plate velocity and 0.1 in. is the distance between the plates
Find the power loss in the inductor : An inductor of 493 mh with a resistance o44 ohms is connected to a power supply with a maximum voltage of 264V and a frequency of 53 Hz. Find the power loss in the inductor
How much does the water in the cloud weigh in pounds : Clouds can weigh thousands of pounds due to their liquid water content. Often this content is measured g/m^3. Assume that a cumulus cloud occupies a volume of one cubic km, and its liquid water content is 0.2g/m^3.
How long is the telescope : A 60-power refracting telescope has an eyepiece with a focal length of 5.5cm. How long is the telescope
What focal length is needed for her objective lens : A grade school student plans to build a 31-power telescope as a science fair project. She starts with a magnifying glass with a focal length of 4.8cm as the eyepiece

Reviews

Write a Review

Civil Engineering Questions & Answers

  What would the concentrationin the effuent be 7 days later

A lagoon with a volume of 1200 m^3 has been receiving a steady flow of a conservative waste at a rate of 100m^3/day for a long enough time to assume that steady-state conditions apply. The waste entering the lagoon has a concentration of 10mg/L.

  How many kilograms of suspended solids are removed

The influent suspended solids concentration to a primary settling tank is 435mg/L. The average flow rate is 0.050m3/s. If the suspended solids removal efficiency is 60 percent, how many kilograms of suspended solids are removed

  Compute the convective heat transfer coefficent

Water at a flow rate of 1 kg/s is flowing in a pipe of internal diameter 5 cm. If the inside pipe surface temperature is 90 degrees C and mean bulk water temperature is 50 degrees C

  What is the force between the bar and block d

Block D sits freely on the homogeneous bar and experiences a gravitational force of 50N. Homogeneous bar AB experiences a gravitational force of 25 N. What is the force between the bar and block D?

  Long cantilever beam of elastic modulus

A 45 kg machine is placed at the end of a 1.6 m long cantilever beam of elastic modulus 200 x 109 N/m and cross-sectional moment of inertia 1.6 x 10-5 m4.

  What is the estimated uncertainty in the length of vector

The base line vector between the base and roving reciever is 8340m and has an accuracy of +/-(1to 2 cm +/-2ppm). What is the estimated uncertainty in the length of this vector

  Calculate the concentration of nacl in mg per l

A waste water sample contains 2.092mmol/L NaCl. Calculate the concentration of NaCl in mg/L. What are the mmol/L concentrations of Na and Cl. Na = 23 and Cl = 35.5.

  Solve for steady-state concentration of both compounds

Atrazine, a neutral triazine herbicide manufactured by the Ciba-Geigy group, undergoes biological and chemical decomposition to formhydroxy-atrazine. a).Assuming a pseudo first order decay constant of 0.01/day for atrazinr and 0.005/dayfor hydroxy..

  Determine the distance downwind to reach the maximum so2

A 45-percent efficient, coal-fired power plant generates output power of 1000 MW (106 kW) and emits SO2 at the legally allowable rate of 0.6 lb SO2 per million BTU of heat into the plant. The stack has an effective height of 250 m.

  Time inventory system for a product

How appropriate might a just in time inventory system be for a product such as roller skates?

  Evaluate company performance in relation to GRI standards

Evaluate company performance in relation to GRI standards and comment on Stigler's theory.

  Annual power cost of the ro system

Is the system within membrane manufacturer's warranty requirement of maximum flux rate of 14 gfd? What is the annual power cost of the RO system?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd