What is rms voltage of source in a single loop series

Assignment Help Electrical Engineering
Reference no: EM13228537

1) If A = 6 + j8 and B = 2-160° what is A x B in polar and rectangular form?


2) If A = 4 - j4 and B = 6120° what is A - B in polar and rectangular form?

3) What is the RMS voltage of the source in a single loop series circuit if Irms = 1A-30° and Ztotal = 100 65°?

4) What is the power dissipated by an electric heater with a resistance of 20? drawing a current waveform of i(t) = 10 sin(60t) Amps?

Reference no: EM13228537

Questions Cloud

Determine the line impedance of thje souece : In a balanced three-phase wye-wye system, the load impedance is 4 + j3 . The source has phase sequence abc and Van = 120
Compute the potential delivered by a voltaic cell operating : Calculate the potential delivered by a voltaic cell operating by the following reaction if all of the dissolved species have a concentration of 0.035 and the pressure of H2 (g) is 1.00 atm.
Explain in detail the greatest challenge facing : Discuss if states should have the ability to work with one another when a cyber-crime is carried out across state lines.
Compute the potential delivered by a voltaic cell operating : Calculate the potential delivered by a voltaic cell operating by the following reaction if all of the dissolved species have a concentration of 0.035 and the pressure of H2 (g) is 1.00 atm.
What is rms voltage of source in a single loop series : 3) What is the RMS voltage of the source in a single loop series circuit if Irms = 1A-30° and Ztotal = 100 65° 4) What is the power dissipated by an electric heater with a resistance of 20? drawing a current waveform of i(t) = 10 sin(60t) Amps
Compute l and lq for the number of trunk lines : Compute L and Lq for the number of trunk lines you determined.
What is rms voltage of source in a single loop series : 3) What is the RMS voltage of the source in a single loop series circuit if Irms = 1A-30° and Ztotal = 100 65° 4) What is the power dissipated by an electric heater with a resistance of 20? drawing a current waveform of i(t) = 10 sin(60t) Amps
The cost recovery for the front end loaders : John Smith, age 31, is single and has no dependents. At the beginning of 2013, John started his own excavation business and named it Earth Movers. John lives at 1045 Center
Compute the potential delivered by a voltaic cell operating : Calculate the potential delivered by a voltaic cell operating by the following reaction if all of the dissolved species have a concentration of 0.035 and the pressure of H2 (g) is 1.00 atm.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Analyzing the blink alive code

Analyzing the Blink Alive code - Embedded Systems Design

  Write an assembly code segment that calls the subroutine

Write an assembly code segment that calls the subroutine New Function if bits 5 and 6 of PORTD equal 1. Write the same code segment in part (a) using structured assembly constructs.

  Explain an organization owns the network

Question about Subnets, An organization owns the network 200.1.1.0/24 and wants to form subnets for 4 departments, with hosts as follows

  Derive a suitable sequential circuit

A sequential circuit has two inputs w 1 and w 2 , and an output, z. Derive a suitable circuit for the given condition.

  Find the minimum sampling frequency of the a-d converter

our senior design team is designing a force sensor to measure a force signal and analyze the signal with a microcomputer (binary system). The analog force signal is between 10 N and 70 N and has the frequency bandwidth of DC - 1000 Hz.

  Explain construct a table showing the current for values

Construct a table showing the current for values of time between 0 and 9 hours at intervals of 1 hour.Hence draw a graph of i against t for 0 is smaller or equal to t is smaller or equal 9.(cannot type in proper inequality symbols)

  At what angle to the normal does the transmitted wave travel

a plane wave is obliquely incident onto the planar interface between mismatched, lossless, nonmagnetic, uniform media, yet undergoes no reflection. If incidence is at 54 degrees to the normal, at what angle to the normal does the transmitted wave ..

  Design by direct implementation the electronic circuits

Design by direct implementation the electronic circuits for equations as the following logic equations using any real 1, 2, or 3 input logic gates. Assume all signals are high true (positive logic) and do not simplify the equations.

  Identify the types of system-building methods

Identify the types of system-building methods used by Dorfman to build its wireless warehouse system.

  What is the most common used op-amp in the industry

1) What are some practical op-amp applications Can you give example and explain why the bop-amp was used in your example 2) What is the most common used op-amp in the industry

  Calculate the power dissipated in the device

An InP TED is 0.5 pm long with a cross sectional area of 10" cm2 and is operated in the transit-time mode.(a) Find the minimum electron density no required for transit-time mode.

  Draw the standard form simulation diagram

How do you draw the standard form simulation diagram given a higher-order differential equation; and how to make adjustments if the output must be put in the state equation form, y=Cx+Du.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd