What is its speed when it hits the ground

Assignment Help Electrical Engineering
Reference no: EM13248114

A ball is thrown upwards with a velocity of 31 m/s at an angle of 35.5 to the horizontal from a point which is 8 m above ground level. Find:

1) The greatest height reached, above the point of projection

2) Find when (time) the ball hits the ground and the horizontal distance travelled.

3) What is its speed when it hits the ground?

Reference no: EM13248114

Questions Cloud

Explain an equilibrium mixture at 225 degrees c : An equilibrium mixture at 225 degrees C contains .14 M NH3 and .18 M H2 for the reaction 3H2(g)+N2(g) 2NH3(g). if the Kc at this temperature is 1.7 X 10^2 what is [N2]
What is the reactive power associated with the added load : An additional variable power factor load is to be added to the factory. The new load will add 320 kW to the factory. The power factor of the variable power factor load is to be adjusted so that the overall power factor of the factory is 0.96 laggi..
Find the balls range to one decimal place : A player kicks a ball from ground level with an initial velocity of 27.00 m/s at 30 degrees above the horizontal. What is the ball's range to one decimal place
Define the equilibrium constant kc for the reaction : the equilibrium constant, Kc, for this reaction is 4.6 x 10^-3. N2O4(g) 2NO2(g). if the equilibrium mixture contains .050 M NO2 what is[N2O4]
What is its speed when it hits the ground : A ball is thrown upwards with a velocity of 31 m/s at an angle of 35.5 to the horizontal from a point which is 8 m above ground level. Find: 1) The greatest height reached, above the point of projection
Determine the direction of this magnetic field : An east-west electric power line carries a 500-A{\rm A} current toward the east. Determine the direction of this magnetic field at Earth's surface directly under the wire
Determine values for a and b that will satisfy constraints : Suppose we want to construct an amplifier with a closed-loop gain of 50. We want the gain to vary by no more than +/- 5% while the open-loop gain varies by +/- 50%. Determine the values for a and b that will satisfy these constraints.
Calculate the charge on each capasitor : A 0.50-?F and a 1.4-?F capacitor (C1 and C2, respectively) are connected in series to a 14-V battery. Calculate the charge on each capasitor assuming the two capacitors are in parallel
Explain synthesize 3-methyl-2-pentene : want to synthesize 3-methyl-2-pentene from 2-chloro-3-methylpentane. Which reagent would you use

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is the fundamental benefit of plc controls

1.Calculate motor speed in revolutions per minute for an eight-pole,50Hz motor. Give the equation and identify its parts; show your math. 2.You need to detect finished products coming down an assembly line.

  Explain a production plant has a requirement for a counter

A production plant has a requirement for a counter that will count 4,000 times before recycling and starting over. How many flip flpos are required?

  Find the magnetic field produced by the two filaments

Two strands of infinitely long current rights carry currents of equal magnitude. Find the magnetic field produced by the two filaments at the midpoint between the two strands. Compare this result if the currents: a) have the same direction

  Design a circuit that will multiply the input voltage

Design a circuit that will multiply the input voltage by +12. That is the output voltage is 12v1 where v1 is the input voltage. All resistors should be at least 12ohms.

  Define a sinusoidal voltage with a peak-to-peak value

A sinusoidal voltage with a peak-to-peak value of 15 v is applied to an RC high-pass filter. If the reactance at the input frquency is zero

  What is the value of the smallest resistor

The voltage drops across three resistors in series are measured 10V, 15V, and 25V. If the largest resistor is 47 ohms, what is the value of the smallest resistor?

  Define frequency divider

Important information about Frequency Divider, Design a frequency divider circuit that will output three pulse frequencies: 25 kHz, 10kHz, and 2.5kHz. Assume that only a 150 kHz CMOS compatible signal is available for the divider input

  Intelligent fan controller based on temperature

Need the coding for the circuits and its a intelligent fan controller based on temperature?

  Find the inductance of the inductor with n turns

Suppose that an inductor is formed by N turns of a conductive wire wound around a magnetic material. The magnetic material forms a circular cylinder of radius r = 10 cm, and height h = 5 cm. The inductance of the inductor turns of N is defined as:..

  Find the minimum product-of-sums for the function

a) Using K-Map, find the minimum product-of-sums for the following function. Circle the term on the map and write the result in algebraic form. b) Draw the block diagram in NOR-NOR.

  Determine the high-pressure turbine work per unit mass

The temperature of steam at the inlets of both turbines is 500°C, and the enthalpy of steam is 3185 kJ/kg at the exit of the high-pressure turbine, and 2247 kJ/kg at the exit of the low-pressure turbine. Disregarding the pump work, determine the w..

  Determine what is the torque of the load

a three phase motor operates at 70% efficiency, out of a 60Hz 480V balanced system of voltages. the motor takes a line current of 70A at a lagging power factor 65%. if the motor is rotating at 3500 rpm, and neglecting fraction, what is the torque ..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd