User Account

All Pages

What is its acceleration

Assignment Help Electrical Engineering
Reference no: EM131076902

An electron in a cathode ray tube (CRT) accelerates from 2.00 " 104 m/s to 6.00 " 106 m/s over 1.50 cm.

(a) How long does the electron take to travel this 1.50 cm?

(b) What is its acceleration?

Reference no: EM131076902

Questions Cloud

What is the amplitude of motion for mass : The maximum speed of a 3.1 -kg mass attached to a spring is 0.70 m/s, and the maximum force exerted on the mass is 13 N. (a) What is the amplitude of motion for this mass?
Use the ansi recommendations for keyway design : 1) he rotating 1050 cold rolled steel shaft shown in the figure below is simply supported at the center of two bearings (denoted by an X) and the only applied load is the constant 7kN load. All dimensions are in mm and all steps in the shaft have ..
Write a c++ interface for a double-ended list : Write a C++ interface for a double-ended list.
What is the speed of the truck : a). How long does it take for the object to reach the ground? b). What is the speed of the truck?
What is its acceleration : (a) How long does the electron take to travel this 1.50 cm? (b) What is its acceleration?
How do social control and social bonding explain conformity : While the pressure to conform is intense, people continue to deviate. Using either Merton's Strain Theory or Becker's Labeling Theory, explain why some people choose to become deviant.
Determining the horizontal and vertical components : a. How long does it take the plate to fall to the floor? b. How far from the base of the counter does the plate hit the floor? c. What are the horizontal and vertical components of the plate's velocity just before it hits the floor?
Repeat the previous programming problem : When the size of the array is greater than 20 and the number of entries in the list is less than half the size of the array, reduce the size of the array so that it is three quarters of its current size.
What could you do to impact the corporate culture : If you were the president in this current scenario, what could you do to impact the corporate culture in order to ensure that your preferred result in this dilemma occurred in the future?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Plot the modulation index necessary to keep the vdc constant

Write the mathlab program to plot the modulation index necessary to keep the Vdc constant at 1200v when the input power factor angle is varied from -60 degrees to 60 degrees.

  Process of commutation in a dc machine

Explain the process of commutation in a dc machine. Explain what are inter-poles and why they are required in a dc machine.

  What is the electric field at z=3m in v/m

What is the potential with respect to infinity at a distance Z above the center of this disk?

  Determine the nominal value and the maximum tolerance

a resistor is required for an application that requires its value to be no less than 7.1k ohms and not more than 7.9k ohms. determine the nominal value and the maximum tolerance of the resistor you could use. explain.

  Determine annual cost of electricity

What are the copper losses and determine their annual cost of electricity and their corresponding costing per kWh

  Consider a 4-bit counter made with jk flip-flops

Consider a 4-bit counter made with JK flip-flops with preset and clear inputs. Describe the changes/additions that need to make the counter reset after counting to 1001. Be sure to state any assumptions that are made.

  Determine when both channels are set to minimum gain

suppose that you have a balanced stereo signal in which the left and right channels have the same voltage amplitude 500 mVpp. This time, however, you want to be able to mix these two channels into a single inverted output

  Determine what is the input capacitance of the amplifier

If the amplifier is fed from a voltage source Vsig having a resistance Rsig = 1kΩ, find the transfer funtion Vo/Vsig as a function of the complex-frequency variable s and hence the 3-dB frequency fH and the unity-gain frequency ft.

  Would choices change if oscillator frequency needed variable

You are designing a general purpose integrated circuit oscillator that will operate at various frequencies, based on the external reactances the user supplies. You expect that the IC will be used as a fixed frequency oscillator in portable equipm..

  Calculate the voltage across the 360-v winding

1-phase 2-winding transformer is rated 30 kVA, 360/90 V, 60 Hz. A source connected to the 360-V winding supplies an impedance load connected to the 120-V winding. The load absorbs 15 kVA at 0.8 p.f. lagging

  Find the signal-to-noise ratio at the bandpass filter output

The message waveform uses a root-raised-cosine line code with α=1. The bandpass filter in the receiver front end has a rectangular frequency response with a bandwidth equal to the absolute bandwidth of the received signal.

  How to simulate the circuit using verilogger

The circuit will have as inputs a minimum of two inputs; the binary equivalent of two decimal numbers of not greater than (10,000)10. The circuit will also produce a minimum of two outputs, the quotient and the remainder.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd