What is allowable power dissipation from the upper surface

Assignment Help Physics
Reference no: EM13964765

A circuit board with a dense distribution of integrated circuits (ICs) and the dimensions of 120mm by 120mm on a side is cooled by a parallel flow of atmospheric air with a velocity of 2 m/s.

From wind tunnel tests under the same flow conditions , the average frictional shear stress on the upper surface is determined to be 0.0625N/m^2. What is the allowable power dissipation from the upper surface of the board if the average surface temperature of the ICs must not exceed the ambient air by more than 25 degrees C ?

Reference no: EM13964765

Questions Cloud

Case study - cbn railway company : Do you think that the decision to lease the locomotives was the best decision for CBN - Case study - CBN Railway Company
Gauss-jordan elimination to solve the system : Set up the augmented matrix while using Gauss-Jordan elimination to solve the system. Provide some notation showing how to proceed from one augmented matrix to the next.
Find the magnitude of the electric flux through the sheet : A flat sheet is in the shape of a rectangle with sides of lengths 0.400 m and 0.600 m . The sheet is immersed in a uniform electric field of magnitude 74.5 N/C that is directed at 20 degrees from the plane of the sheet. Find the magnitude of the e..
Amount of labor-hours based on shifts : Write a matrix A that denotes the amount of labor-hours based on shifts and each type of labor (carpenter, electrician, or plumber). Write a column vector B representing labor costs per shift.
What is allowable power dissipation from the upper surface : From wind tunnel tests under the same flow conditions , the average frictional shear stress on the upper surface is determined to be 0.0625N/m^2. What is the allowable power dissipation from the upper surface of the board if the average surface te..
Record the formula of the gas you selected to run experiment : This experiment extrapolates the behavior of an ideal gas down to coldest possible range. In reality, the gas would condense into a liquid as it approaches absolute zero. Does this affect the conclusion reached regarding the value of absolute zero..
Determine appropriate logistics methods in various scenarios : Identify and compare at least four to five factors (cost, shelf life, weather, etc.) that impact transportation needs. Determine appropriate logistics methods in various scenarios (local, out-of-state, regional, coast-to-coast, and global)
Identify an appropriate study design : Discuss the strengths and weaknesses of the design supporting your selection.
What is the bound charge density in the charged region : In one particular instance a 0.1 microampere beam bombarded an area of 25 square cm of Lucite (epsilon-sub-r = 3.2) for 1 second, and essentially all the electrons were trapped about 6 mm below the surface in a region about 2mm thick. the block wa..

Reviews

Write a Review

Physics Questions & Answers

  Find what fundamental frequency will it produce

A certain organ pipe, open at both ends, produces a fundamental frequency of 296 Hertz in air. find what fundamental frequency will it produce

  What is the net force on each side of the box

A container of hot water at 80 degrees cools to 79 degrees in 15 seconds while it is placed in a room that is t 20 degrees. Use newton's law of cooling to estimate the time it will take for the container to cool from 50 degrees to 49 degrees.

  Calculate how long a de-orbit burn must last in minutes

Calculate how long a de-orbit burn must last in minutes and secondsto achieve the Shuttle’s change in altitude from 212 miles to60 miles at perigee.

  What is the charge before and after the mylar is withdrawn

Two 8.0mm×8.0mm electrodes with a0.10-mm-thick sheet of Mylar between them are attached to a 9.0V battery. What is the charge before and after the Mylar is withdrawn

  Derive an expression for the circuit current

A 150-? resistor is connected in series with a 0.250-H inductor. The voltage across the resistor is vR=(3.80V)cos[(720rad/s)t]. Derive an expression for the circuit current

  What is the coefficient of linear expansion of the metal

A flat piece of glass is supported horizontally above the flat end of a 11.0 cm long metal rod that has its lower end rigidly fixed. The thin film of air among the rod and the glass is observed to be bright when illuminated by light of wavelength 500..

  The position of the particle as a function of time

The position of the particle as a function of time expressed by the equation position vector r (t) = (at2 + bt) i + (ct + d) j with a, b, c, and d are constants that have the appropriate dimension. Determine the particle displacement vector between t..

  How many times are the cars side by side

Cars A and B move in the same direction in adjacent lanes. For that value of aB, how many times are the cars side by side

  What is the function of charge inversion layer

illustrate the cross section view of n-channel MOSFET. What is the function of charge inversion layer

  Evaluate what is the maximum compression of the spring

A wheeled cart with a mass of 0.50 kg is rolling along a horizontal track at a constant velocity of 2.0 m/s, What is the maximum compression of the spring

  Does one mass reach the midpoint before the other

They are dropoped simutaneously from a cliff. Compare their accelerations at midpoint in their fall. Does one mass reach the midpoint before the other?

  Evaluate the magnitude of the centripetal acceleration

Determine the magnitude of the centripetal acceleration of an object on the surface of the Earth at latitude of 61.5°. Consider the Earth to be a sphere of radius R = 6.38 x 106

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd