Reference no: EM13714433
1. Using the iron-Carbon equilibrium phase diagram, please describe the lines of transformation to austenite during heating with carbon content < 0.77 wt.%. (Hint: use the transformation starting line (A1) and the transformation finish line (A3)).
2. What is a typical pearlite structure?
3. What is the difference between TTT diagram and CCT diagram? What is the relation between them? How are they used to estimate a quenching hardening process in a heat treat shop?
4. What is the harden ability, and how will the alloy and carbon contents affect it?
5. What are the three phases at the liquid and solid interface during an immersion oil quenching process?
6. Why press quench is used in some quenching hardening process with tremendous cost increase?
7. List five important material properties to understand a steel part’s responses during a quench hardening process.
8. What is the main difference between phase transformations from austenite to marten site and from austenite to pearlite?
9. What is transformation induced plasticity (TRIP)?
10. Please list five critical process parameters during an oil quench hardening process (quenching hardening may include heating process).
|
Entrepreneurs is starting a new data storage
: An enterprising group of entrepreneurs is starting a new data storage and retrieval business, SecureStore, Inc. For a fee, the new company will accept digitalized data (text and images, multimedia), and store it on hard drives until needed by t..
|
|
Heat engine is powering a carnot cycle refrigerator
: For a Carnot cycle, with water as the operating fluid, the following steps are known to occur. The water changes from saturated liquid to saturated vapor at 200°C as heat is added. Heat is rejected at constant pressure at 20 kPa.
|
|
Create a new table for suppliers contact information
: 1. Create a new table for Suppliers' contact information and set the primary key and appropriate data types for the fields. The table should at least contain the following information: a. Company name and address b. Representative's name, pho..
|
|
What is the mass flow rate of air-heat exchanger
: A compressor receives 0.1 kg/s R-134a at 150 kPa, -10C and delivers it at 1000 kPa, 40C. The power input is measured to be 3 kW. The compressor has heat transfer to air at 100 kPa coming in at 20C and leaving at 30C (i.e. like a heat exchanger). What..
|
|
What is a typical pearlite structure
: Using the iron-Carbon equilibrium phase diagram, please describe the lines of transformation to austenite during heating with carbon content
|
|
Air conditioning of a house through use of solar energy
: Consider the air conditioning of a house through use of solar energy. At a particular location, experiment has shown that solar radiation allows a large tank of pressurized water to be maintained at 175°C. During a particular time interval, heat in t..
|
|
Embracing enterprise risk management
: The following material may be useful for the completion of this assignment. You may refer to the documents titled "Embracing Enterprise Risk Management: Practical Approaches for Getting Started" and "Developing Key Risk Indicators to Strengthen..
|
|
Piston and cylinder with an isobaric process
: Water at 100 kPa, 25C is brought to the boiling point in a piston/cylinder with an isobaric process. The heat is supplied by a heat pump with the cold side at the ambient temperature of 25C. Assume that the whole process is reversible and find the wo..
|
|
Gas within piston-cylinder assembly executes carnot power
: A gas within a piston-cylinder assembly executes a Carnot power cycle during which the isothermal expansion occurs at TH = 720 K and the isothermal compression occurs at TC = 340 K. Determine: (a) the thermal efficiency (b) the percent change in ther..
|