Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Drift velocity-- the actual (physical) velocity of electrons along the wire.
Transmission velocity-- the rate at which information can be transmitted electronically using conducing wires.
How is it possible that the transmission velocity is so much faster (close the speed of light)? Is it clear what my confusion here is? What is the information transmission? In a circuit with no active devices, what information is possibly being transmitted? Is this only reffering to circuits with active devices?
Eigenfunctions and LTI systems, The eigenfunction property is only valid for LTI systems. Consider the cases of nonlinear and of time varying systems.
A 415V to 11 kV transformer has a rating of 200 kVA. The winding resistance and leakage reactance when referred to the primary are 0.014 and 0.057 ohms respectively.
What is the BER at the output of the receiver in clear air conditions, and the average time between errors? Give your answer in years, days, or hours as appropriate. Assume an implementation margin of 0.5 dB.
A three-phase overhead transmission line has a per-phase resistance of 0.15 ohm/km, and a per-phase inductance of 1.3263 mH/km.
Discuss how the angle of the incident light affected the solar cell? How could solar cell designs and/or installations be designed to counter this affect?
Power factor correction, Three parallel impedances in rectangular form as follows
In a typical mobile communications base station (or cell site), a radio frequency (RF) signal is amplified in the base station and then sent (over cable) to the antennas at the top of the tower.
A certain 11 V dry-cell battery, completely discharged, requires a current of 100 mA for 1.2 hr to completely recharge. What is the energy storage capacity of the battery, assuming the voltage does not depend on its charge status?
calculate inductance of sensor for air gap of 1mm and 3mm?
During an AP, the membrane potential typically moves from -70mV to +20mV and back again. In a cell with 10um radius and 1uF/cm^2, how many charges need to move across the membrane (and back again) to get this 90 mV voltage fluctuation?
SR flip flop from D Flip flops, Show how to build a rising edge triggered SR flip-flop using a rising edge triggered D flip-flop and combinational logic.
Block diagram and equations for control system water fill, Develop a control system to fill a container with water after it is emptied through a stopcock at the bottom
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd