What impedance in parallel with capcitor will absorb power

Assignment Help Electrical Engineering
Reference no: EM13274015

A voltage source 100(angle 0 degrees) is in series with a 200 ohm resistor and a cpacitive reactance of -100 ohms.
a) What impedance,Zl, in parallel with the capcitor would absorb maximum AVERAGE power?
b) What is this maximum power?

Reference no: EM13274015

Questions Cloud

What is the pole location for the amplifier with a gain : Compare the Bandwidths of Two Inverting Amplifiers a) Use Signal Express to measure the 3 dB bandwidth for the inverting amplifier with a gain of -10 and for an inverting amplifier with a gain of -50. b) How does the bandwidth change with gain
Estimate the maximum speed of the mass : A spring is hanging from the ceiling. Attaching a 440gg mass to the spring causes it to stretch 18.0cmcm in order to come to equilibrium. What is the maximum speed of the mass
Explain the degree of unsaturation of an organic compound : Determine the degree of unsaturation of an organic compound with the molecular formula C7H6O2. interpret the value found in term of functional group of the compound.
Explain a molar absorbance coefficient : That concentration (g / ml) should be prepared with a substance weight of 200g/mol melocular to give an absorbance of 0.8? Assume that the substance has a molar absorbance coefficient of 16,000 and that the cell has a light path length of 1 cm.
What impedance in parallel with capcitor will absorb power : A voltage source 100(angle 0 degrees) is in series with a 200 ohm resistor and a cpacitive reactance of -100 ohms. a) What impedance,Zl, in parallel with the capcitor would absorb maximum AVERAGE power
Calculate how long is the lamp chain : It is said that Galileo discovered a basic principle of the pendulum - that the period is independent of the amplitude, How long is the lamp chain?
What are the firms earning per : The board of Patto Co decides to pay 0.03 shares of stock to the holders of each share of common stock such that the holder of 1,00 shares of stock would receive 30 shares of stock.
Explain lewis structure and identify the reacant acting : Draw lewis structure and identify the reacant acting as an acid and base and indicate if it is a bronsted lowry, lewis acid, or both
What can you say about the irr of the project : Based on the NPV analysis, should Firm XYZ purchase this new equipment? Show your work

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine values of resistance-r and capacitance-c

A resistor R, capacitor C, and voltage source Vs= 100 cos 300t Vare all in series. If the average power dissipated by the resistor is 150 W and the rms capacitor voltage is $) V, determine R and C.

  How to measure the current waveform through an inductor

If the voltage across a capacitor is a square wave, predict the resulting current waveform (draw the voltage and current waveforms). Repeat the process when the voltage across the capacitor is a sine wave.

  What is the rms voltage of square wave

A square wave has a max value of 22 volts, a min value of -46 volts, and a frequency of 44 Hz. Note that it is not centered around the t-axis. what is its rms voltage?

  Draw per-unit zero-negative and positive sequence networks

Three single-phase, two-winding transformers, each reated 450 MVA, 20 kV/288.7 kV with leakage reactance Xeq=0.12 per unit, are connected to form a three-phase bank. The high voltage windings are connected in Y with solidly grounded neutral.

  Determine the maximum gain of the antenna

A single-turn resonant circular loop with a /8 radius is made of copper wire with a wire radius of 10^4 pi f/2 and conductivity of 5.7 × 10^7S/m. For a frequency of 100 MHz, determine, assuming uniform current

  How hot would a conventional pipe have to get to burst

How hot would a conventional pipe have to get to burst and why. Does it vary according to what material the pipe is made of. Which are the strongest. What are weak ones

  Determine peak current during the discharge of capacitance

A person shuffling across a dry carpet can be approximately modeled as a charged100-pF capacitance with one end grounded. If the person touches a grounded metallic object such as a water faucet.

  Why has lead-free solder replaced lead-based solder

1. What is the purpose of core in hollow solder wire 2. What is tinning, and why is it important 3. Why is safety so important when soldering 4. Why has lead-free solder replaced lead-based solder Be sure to properly cite any sources of information.

  Find the magnitude of the electric field at given distance

A sphere of radius 100mm has a charge 4 C uniformly distributed throughout its volume. Find the magnitude of the electric field at distance 100.1 mm from the centre of the sphere.

  Determine the magnitude of net charge stored on each plate

Calculate the energy stored by a 1 μF capacitor with 200V applied across its terminals. Determine the magnitude of net charge stored on each plate and the total net charge on both plates.

  Implement the arithmetic circuit that adds two 10-bit number

Write the VHDL text file for a circuit to implement the arithmetic circuit that adds two 10-bit numbers (A and B) and subtracts a third 10-bit number (C) from the result. Use INTEGER types.

  What is the measured period and frequency of the waveform

An oscilloscope shows the period of an ac waveform to be 3.5 horizontal divisions when the timebase control is set to "10 ms/Div". What is the measured period and frequency of the waveform

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd