What impedance does a driving generator have

Assignment Help Electrical Engineering
Reference no: EM13250764

A one-quarter wavelength piece of 75 ohm microstrip line has a capactive load of XC = 22 ohms. What impedance does a driving generator have?

Reference no: EM13250764

Questions Cloud

An auto manufacturer uses : An auto manufacturer uses 500 tons of steel per day. The company pays $1100 per ton of steel purchased, and each order incurs a fixed cost of $2250. The holding cost is $275 per ton of steel per year. Using the EOQ model, calculate the optimal order ..
Determine the specific gravity of solids : a soil below the water table has a density of 120 lb/ft^3 and a void ratio of .82. determine the specific gravity of solids
Explain the temperature in the room remains unchanged : Eventually, the water cools to 25.0 degrees celsius while the temperature in the room remains unchanged. Calculate deltaS(sys), deltaS(surr), and deltaS(univ) for this process.
Determine the impact on the economy : Determine the impact on the economy if the central bank in the U.S. used inflation targeting. Explain your rationale.
What impedance does a driving generator have : A one-quarter wavelength piece of 75 ohm microstrip line has a capactive load of XC = 22 ohms. What impedance does a driving generator
Gravel from the sault ste-case : Sand and gravel (aggregates) operators in Sault Ste. Marie sell most, if not all, of their products within the Sault Ste. Marie area. Why that case?
Discuss the pros and cons of central banks setting policy : Discuss the pros and cons of central banks setting policy based on rules as opposed to setting policy based upon the discretion of policymakers at each policy meeting.
Calculate the l and c values of an l network : Calculate the L and C values of an L network that is to match a 9 ohm transistor power amplifier to a 75 ohm antenna at 122 MHZ.
How many units should be ordered each time : An order should be placed whenever total back-ordered demands sum to what?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Explain in you own words how a modem works

Describe in you own words how a modem works and what steps the data goes through to be sent from one terminal to another via modem.

  Explain the parking lot of the spenditall megamall

The parking lot of the Spenditall Megamall has an area of 128 ac. It is partially landscaped to provide some areas of grass. Assume that an average of 63% of the water that falls on the parking lot will flow

  To what value of capacitance pf should the capacitor change

The tuning capacitor of a Wien bridge oscillator is 100 pF and the frequency is 5 kHz. To what value of capacitance pF should the capacitor be changed to if the frequency is to be changed to 2 kHz

  Draw hardware logic diagram using and-or logic

Design a counter to count even numbers between 0 and 15. Therefore states will be 0 -> 2 -> 4 -> 6 -> 8 -> 10 -> 12 -> 14 -> 0. If any unused state is encountered bewteen 0 and 7, then the counter should go back to initial state 0.

  Determine the charge and current flowing in the circuit

The capacitor in an RC circuit (R=10.0k Ohms and C=25.0uF) is initially uncharged. Determine the charge and current flowing in the circuit at 0.40 time constants (t=0.40 tau) after the circuit is connected to a 9.00 V battery.

  What is difference between multiplexing and multiple access

What is the difference between multiplexing and multiple access?

  Determine the standing wave pattern for the voltage

A sinusoidal voltage wave of real amplitude B0, and frequency w, and phase constant B, propogate in the forward z direction toward the shorted load end in a lossless transmission line of characteristic impedance Z0.

  Explain how the electrons and holes move through the device

trace how the electrons and holes move through the device under the two different biasing conditions. Explain how these three devices work in terms of holes and electrons.

  Determine the transfer function for a second order filter

Determine the transfer function for a second order band pass filter with following specifications. Chebyschev type with 1 db ripple in the pass band Lower cutoff frequency = 100 radians/sec

  Write the ybus matrix

Identify the bus types and the unknown variables of the power flow problem. Write the complete set of equations needed to solve the load flow problem.

  Find the smallest possible diameter

A micrometer caliper is used to measure the diameter of a bolt and a reading of 0.768 inches is obtained. Based on this measurement, find the smallest possible diameter and the largest possible diameter.

  What is the overall noise figure referred to the input

A mixer stage has a noise figure of 20 dB. This mixer stage is preceded by an amplifier which has a noise figure of 9 dB and an available power gain of 15 dB. what is The overall noise figure referred to the input.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd