Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Question 1:Describe the two layers: LLC & MAC, and how are they different from what is available in the TCP/IP protocol? Why do we need these two extra layers for a LAN?
Question 2:An asynchronous device,such as teletype, transmits characters one at a time with unpredictable delays between characters. What problems, if any, do you foresee if such a device is connected to a LAN and allowed to transmit at will (subject to gaining access to the medium)? How might such problems be solved?
Question 3:Explain why is it when a load exceeds the network capacity, delay tends to increase?
Question 4:What is the difference between a hub and a layer 2 switch ?
Question5:A tree topology is to be provided that spans two buildings. If permission can be obtained to string cable between the two buildings, one continuous tree layout will be used. Otherwise, each building will have an independent tree topology network and a point-to-point link will connect a special communications station on one network with a communications station on the other network. What functions must the communications stations perform? Repeat for ring and star.
Assume that we try to predict this sequence with a BHT using one-bit counters. The counters in the BHT are initialized to the N state. Which of the branches in this sequence would be mis-predicted?
Zener diode, Can You show me how to solve the following: If a 5k resitor is connected between the cathode of a 6.2V ZENER diode and a 12V power supply.
Understanding low, high and band pass filters, A signal in the IF section of an FM radio receiver occupies the frequency band 10.61 MHz to 10.79 MHz. Compute the bandwidth of this signal.
Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
Write a brief explanation of the principles of the super-heterodyne receiver. It may help to use a simple block diagram to express the process. Explain the purpose of the Intermediate Frequency amplifiers,
What is the primary purpose of a resistor in series with a LED being driven by a flip-flop?
A microwave system requires a +4-dBm audio level to provide 100% modulation. Determine the voltage level required if this is a 600 ohm audio system.
The ATSC broadcast television system used in the US transmits video signals at an average rate of 18.34 Mbps and employs 8-VSB modulation.
Can you confirm-The outputs of two"NAND" gates are connected to the inputs of an "EXCLUSIVE OR" gate.Each of the "NAND" gates has one input at logic high level and the other input
In 1988, the average wage rate was $9.45 an hour and in 2008 the average wage rate was $18.00 an hour. The CPI in 1988 was 118.3 and in 2008 it was 215.3 . Which real wage rate is higher?
A circuit contains two devices that are connected in parallel. If the resistances of one of these devices is 12ohms and the resistance
What is the shape of the spectrum of the signal? What is the extent of the spectrum in the frequency domain? What is the unit that is applied to the magnitude of the spectrum?
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd