Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
What is the slope of the high-frequency asymptote for the Bode magnitude plot for a first-order high pass filter? The low-frequency asymptote? At what frequency do the asymptotes meet?
Consider a MOS device with the following parameters: Aluminum gate, p- type silicon substrate, oxide thickness of 20nm, and surface fixed oxide charge of 4x1010 cm-2 (a) Determine the doping concentration such that the threshold voltage is 0.5V.
Derive a rule to estimate the network resistance when one of the resistors has a much smaller resistance than the other two and derive a rule to estimate the network resistance when two of the resistors have much smaller values.
A linear time-invariant continuous-time system responds to the following inputs with the corresponding outputs:Ifx(t) = u(t), then y(t) = 2(1- e^-t)u(t) and if x(t) = cost,then y(t) = 1.414 cos(t - pi/4).
How much we need to pay for the electricity cost in 61 days when a water-desalination machine runs normally from 8AM to 4PM every day. (It draws 25A in its warming-up time (15 minutes) and draws, on average, 7A in its normal working time at 240V).
At the output of a two terminal DC network, when no load is attached , the voltage measured as 6 volts. When a load of 1 kiloohms is connected across output, the voltage at the output drops to 4 volts. Create a Thevenin Equivalent model of this ne..
Determine the dynamic behavior of the tank concentrations (CA0 and CA) in response to a step change in inlet concentration by 0.925 mole/m3. Estimate the time it takes until 63% of the change in outlet concentration, CA has occurred.
A sirloin steak (e'r = 52.4, µr = 1, tan dc = 0.33) is to be heated in a microwave oven operating at 2.45 Ghz. (a) Determine the uniform plane wave penetration depth. (b) Determine the complex impedance of the material.
With this particular connection can the rated power for the primary side be supported bythe secondary side? If not, why and how could the transformer be changed to supportrated power without changing the voltage characteristics of the set-up?
Suppose a uniform magnetic field exists ina finite regionof space. Can a charged particle be injected into this region from the outside and remain trapped in the region by magnetic force alone
a resistor is required for an application that requires its value to be no less than 7.1k ohms and not more than 7.9k ohms. determine the nominal value and the maximum tolerance of the resistor you could use. explain.
A Dc machine is connected across a 240-volt line. It rotates at 1200 rpm and is generating 230 volts. the armature current is 40amps. A) Is the machine functioning as a generator or motor
A storage tank has a Diameter of 20ft and a height of 10ft. The output volumetric flow from this tank is given by fout(t)=2h(t) where h(t) is the height of the liquid in the tank. At a particular time the tank is at steady state with an input flow..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd