What features might you look for on the fracture surfaces to

Assignment Help Civil Engineering

Reference no: EM13555135

Manufacturing process that unintentionally introduces cracks to the surface of a part was used to produce load-bearing components. The design requires that the component be able to withstand a stress of 450 MPa. The component failed catastrophically in service.

You are a failure analysis engineer who must determine whether the component failed due to an overload in service or flaws from the manufacturing process. The manufacturer claims that the components were polished to remove the cracks and inspected to ensure that no surface cracks were larger than 0.5 mm. The manufacturer believes the component failed due to operator error. It has been independently verified that the 5-cm diameter part was subjected to a tensile load of 1MN (106 N). The material from which the component is made has a fracture toughness of 75 MPa (m) ½ and an ultimate tensile strength of 600 MPa. Assume external cracks for which f =1.12.

a) Who is at fault for the component failure, the manufacturer or the operator? Show your work for both cases.

b) In addition to the analysis that you presented in (a), what features might you look for on the fracture surfaces to support your conclusion?

Reference no: EM13555135

Questions Cloud

Compute the gravimetric water content : A sample of clay was obtained from a point below the water table. An oven-drying test performed on this sample resulted in the following data:

Calculate air-dry moisture content : The weight of a sample of coarse aggregate was measured under various conditions with the following results:

What would be the difference in average annual water require : If 100 acres of farmland were developed for urban housing (four houses per acre), what would be the difference in average annual water requirements after the change over? Assume that the irrigation requirement is 2.5 acre-ft of water for a growing se..

What concentration of ozone is sometime used : What concentration of Ozone is sometime used as a disinfectant for drinking water. Ozone is highly reactive it will react benign species found in water, as well as the pathogens it is intended to kill. It found that ozone reaction in water nearly fol..

What features might you look for on the fracture surfaces to : Manufacturing process that unintentionally introduces cracks to the surface of a part was used to produce load-bearing components. The design requires that the component be able to withstand a stress of 450 MPa. The component failed catastrophically ..

What is the maximum weight of the paddlers and other gear : A simple "box-like" canoe has outer dimensions of 15.0 ft in length, 2.0 ft in width, and 1.0 ft in depth. The canoe shell is made of concrete with a specific weight of 58.0 lbs/ft^3 and contains 15.0 lbs of steel reinforcement with negligible volume..

Estimate the average hourly average daily and minimum hour : Estimate the average hourly, average daily, and minimum hourly residential sewage flows from an area serving a population of 1500 people. Assume that the lenghth of sewer and house drains equals 3.0 km and that infiltration occurs

Compute the monthly payment for the loan : Your company is considering the purchase of new earth moving equipment. The total purchase is $240,000 and we pay with $100,000 cash and borrow the rest. (12% per year nominal, compounded monthly for 5 years). The machines last for 7 years and will b..

Determine the magnitude and directional sense : The railway crossing gate consists of the 100 kg gate arm having a center of mass at Ga and the 250 kg counterweight having a center of mass at Gw. Determine the magnitude and directional sense of the resultant moment produced by the weights about po..

User Account

All Pages