What duty cycle signal is required to run the motor

Assignment Help Electrical Engineering
Reference no: EM13266161

A DC motor has an input of 0-5V and runs at speeds from o to 80 rpm. What duty cycle signal is required to run the motor at approximately 20 rpm?

Reference no: EM13266161

Questions Cloud

Explain polypetide chains that one detergent molecule : A solution of 0.1% sodium dodycl sulfate (SDS) binds so strongly to polypetide chains that one detergent molecule is sufficient to saturate two amino acid residues.
Explain polypetide chains that one detergent molecule : A solution of 0.1% sodium dodycl sulfate (SDS) binds so strongly to polypetide chains that one detergent molecule is sufficient to saturate two amino acid residues.
What is the bonds expected rate of return : ExxonMobil 20-year bonds pay 6 percent interest annually on a $1,000 par value. If bonds sell at $945, what is the bonds' expected rate of return?
Explain polypetide chains that one detergent molecule : A solution of 0.1% sodium dodycl sulfate (SDS) binds so strongly to polypetide chains that one detergent molecule is sufficient to saturate two amino acid residues.
What duty cycle signal is required to run the motor : A DC motor has an input of 0-5V and runs at speeds from o to 80 rpm. What duty cycle signal is required to run the motor at approximately 20 rpm
Explain what are the advantages and disadvantages of lewis : What are the advantages and disadvantages of Lewis, condensed, and line-angle structural formulas
What is input resistance of the resulting current divider : A designer searches for a simple circuit to provide one-third of a signal current I to a load resistance R. Suggest a solution using one resistor. What must its value be. What is the input resistance of the resulting current divider.
Results of globalization : Outsourcing, one of the results of globalization, is an emotional issue for many people these days. What do you think about the recent trends in outsourcin.
What is the radius of a bobsled turn banked : What is the radius of a bobsled turn banked at 75.0° and taken at 30.0 m/s, assuming it is ideally banked

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Explain capacitance of parallel plates capacitor

Explain Capacitance of parallel plates capacitor, Relative permitivity is 500, The area is one square meter, The distance between the plates is 0.001 meters

  How much power is delivered to the end of the combined fiber

Ten multimode glass fibers (n1 = 1.48, n2 = 1.45) are spliced together. Each fiber is 2 km long and has a loss rate 2-dB/km. Each splice adds 1 dB of loss. If the output power of the source is 7 dBm and radiates uniformly in a 60 degree half cone

  Find the mean of e covariance martix for v

X & Y are Gaussian random variables with E[X]=1, E[Y]=2, E[XY]=.1, VAR[X]=5 & VAR[Y]=10. Define the vector V=(matrix) 1 1;1 -1 matrix X;Y. Find the mean of E[V], covariance martix for V, use matrix notation

  What is the rms value of the largest sine-wave input

An amplifier with 40 dB of small-signal open-circuit voltagegain, an input resistance of 1M-ohm ,and an output resistance10-ohm drives a load of 100-ohm .What voltage and power gains(expressed in dB) would you expect with the load connected

  What is minicircuits rf mixers would be suitable for design

You are designing a 2.4 GHz receiver with a 140 MHz IF. System design constraints require that the local oscillator power be minimized to reduce the potential for interference to other systems as well as to reduce the receiver power consumption.

  Find v-high to obtain twice rated current

John's house is served electrically by a single phase transformer rated 15 kVA, 8160 / 220 V, 60 Hz. The leakage reactance of the transformer is 400 ohms referred to the high side. John wants to replicate an interesting EEE 360 experiment

  What numerical data form the contents of the stack frame

The system works as follows. When the main program starts to run, the microprocessor commands the A/D to convert. The microprocessor then sits in a dummy loop until the A/D interrupts, after it has completed the conversion and data is available.

  What current will be required for the plating operation

An electronics manufacturer makes corrosion-resisitant, gold-plated connectors. Each connector is cylindrical in shape with a diameter of .100 cm and a length of 1.0 cm. Each connector is to be coated with a 10 -(micrometer) gold layer.

  Give the enthalpy change h for the given reaction

Suppose 33 mL of 1.20 MHCl is added to 42 mL of a solution containing excess sodium hydroxide, NaOH, in a coffee-cup calorimeter. The solution temperature, originally 25.0C, rises to 31.8C.

  Determine the capacitance of a parallel-plate capacitor

determine the capacitance of a parallel-plate capacitor having plates 14cm by 30cm separated by 0.01mm. The dielectric has (epsilon)(r)=15

  Compare num of transmission path required in hybrid topology

A star-bus hybrid topology consists of a main three branch star toplogy with each branch connecting three stations in a bus topology. This toplogy is changed to a new bus-ring hybrid topology with main five station bus topology.

  Determine the value of the transfer function of the filter

The input to a certain filter is given by Vin(t)=2cos(10000pi*t-15deg) and the steady state output is given by Vout(t)=5cos(10000pi*t+25deg). Determine the (complex) value of the transfer function of the filter for f=5000 Hz.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd