What do will result if the concentration of the waste

Reference no: EM13552917

The discharge from the Renenutet sugar beet plant causes the DO at the critical point to fall to 4.0 mg/L. The Meskhenet Stream has a negligible BOD and the initial deficit after the river and wastewater have mixed is zero. What DO will result if the concentration of the waste(L_w) is reduced by 50%? Assume that the flows remain the same and that the saturation value of DO is 10.83 mg/L in both cases.

Reference no: EM13552917

Questions Cloud

What is friction of k and how does it work into the reaction : A 400 lb crate is on a 20 degree incline. If a 120 lb horizontal force (P), pushes on the crate (upwards), determine the normal and frictional forces acting on the crate. Take friction of surface = 0.3 and friction of k = 0.2?

Determine the location of the hydraulic jump relative : A rectangular channel of width 12 ft has an upstream slope of 0.02 ft/ft and a downstream slope of 0.0005 ft/ft. Both reaches have lengths of 500 ft. The upstream reach has a Manning's roughness of 0.016 and the downstream reach has a roughness of 0...

Find the hydraulic conductivity of the aquifer : A confined aquifer 30 m thick has been pumped from a fully penetrating well at a steady rate of 5000 m3/day for a long time. Drawdown at an observation well 15 m from the pumped well is 3.0 m

Who else was there at the time and how they might have : Develop a timeline up to 1900 with considerable expansion of Henry Martyn Leland's work at The Springfield Armory, Colt, Brown & Sharpe, and L & F (in Detroit)

What do will result if the concentration of the waste : The discharge from the Renenutet sugar beet plant causes the DO at the critical point to fall to 4.0 mg/L. The Meskhenet Stream has a negligible BOD and the initial deficit after the river and wastewater have mixed is zero

Find the standard deviation of the clearance : It is possible to adjust the mean hole diameter. To what value should it be adjusted so as to maximize the probability that the clearance will be between 0.05 and 0.09 cm?

Determine the horizontal force p that must be applied : The wedge is used to level the member. Determine thehorizontal force P that must be applied to move the wedge to theright. The coefficient of static friction between the wedgeand the two surfaces of contact is

V is the shear force at the same point : Follow the derivation of the following equations for deflections of a beam, filling in all the required assumptions and steps in the derivations.EIv'' = M EIv''' =V EIv'''' = ? q where v is the deflection of the beam, E is Young's modulus

Derive an expression for small flow rates over a spillway : Derive an expression for small flow rates over a spillway, in the form of a function including dimensionless quantities. Use dimensional analysis with the following parameters

User Account

All Pages