What distance on 5 grade should be laid out with a tape

Assignment Help Civil Engineering
Reference no: EM13315425

What distance on 5% grade should be laid out with a tape that measures 30.010 m under field conditions if the horizontal distance is to be 430.00m?

Reference no: EM13315425

Questions Cloud

Determine the governing load combination for both moments : A beam that is part of a rigid frame has end moments and mid-span moments for dead, live, and earthquake loads. Determine the governing load combination for both negative and positive moments at the ends and mid-span of the beam.
Calculate the total weights and values of each subset : Use the decrease-by-one technique to generate the power set and calculate the total weights and values of each subset, then find the largest value that fits into the knapsack and output that value.
Determine what is the actual length of the line for steel : A 100ft steel tape measure correctly when supported throughout its length under a tension of 1- lb and at a temperature of 72F.It is used on the field at a tension of 18 lb and supported at the two ends only.
How many watts of power would it take to heat 1 l of water : How many watts of power would it take to heat 1 L of water(weighing 1.0 kg) by 10 degrees Celsius n 1.0 h Assume no heat losses occur, so all of the energy expneded goes into heating the water.
What distance on 5 grade should be laid out with a tape : What distance on 5% grade should be laid out with a tape that measures 30.010 m under field conditions if the horizontal distance is to be 430.00m
What measurements should be laid out to establish a distance : a tape is calibrated and found to measure 100.04ft between the 0- and 100-ft marks. what measurements should be laid out to establish a horizontal distance of 682.25ft
Find the time interval between wave peaks hitting the boat : Suppose you are in a high-speed boat moving at 18.0 m/s directly into approaching 1.10 m wavelength wave. What is the time interval between wave peaks hitting the boat
What is the diameter d of the smallest-sized particles : In a hydrometer test, the data recorded at 60 minutes after the start of the test are as follows: Gs = 2.6, temperature of water T = 24°C and L = 9.2 cm. What is the diameter D of the smallest-sized particles
What is the phase constant of the other wave : Two sinusoidal waves of the same period, with amplitudes of 5.5 and 7.5 mm, travel in the same direction along a stretched string; What is the phase constant of the other wave

Reviews

Write a Review

Civil Engineering Questions & Answers

  Design assumptions for a rapid-mix tank have been made

Your boss has assigned you the job of designing a rapid-mix tank for the new water treatment plant for the town of Waffle. The design flow rate is 0.050 m^3/s. The average water temperature is 8 degrees celcius.

  Determine the force in chains ac and ad during the lift

the 3.5mg engine is suspended from a 500 kg spreader beam and hoisted by a crane which gives it an acceleration of 4m/s^2 when it has a velocity of 2m/s. determine the force in chains AC and AD during the lift.

  What should be the design capacity of the distribution pipes

A water supply system is being designed to serve a population of 200,000 people with an average per-capita demand of 600L/Person-day (peak demand factor is 1.8) and a needed fire flow of 28,000 L/min.

  How much more flow in cfs will be attained with project

If a 96-inch brick sewer (n = 0.015) is laid on a slope of 0.01% is set to be rehabilitated with GIPL (n = 0.01) that will need 2-inches all around it. How much more flow, in cfs will be attained with this project

  Four-lane highway for adequate ssd

A horizontal curve was designed for a four-lane highway for adequate SSD. Lane widths are 12 feet, and the superelevation is 0.06 and was set assuming maximum fx.

  What will lowest dissolve oxygen concentration be downstream

A wastewater is discharged to a stream with a reoxygenation constant of 0.5 day-1 and a velocity of 1 m/sec. The oxygen saturation concentration in the stream is 11 mg/L.

  Calculate the re-circulating load in the secondary crusher

A two stage crushing operation feeds 0.6 m diameter ore into a primary crusher at a rate of 25mt/hr. 80% of the ore feeds through an 0.2m screen into a secondary crusher. 65% of the ore from the secondary crusher comes out of a 50mm screen.

  Value of the mass of the cylinder

A one meter diameter cylindrical mass is connected to a 2 meter wide rectangular gate. the gate is to open when the water level drops below 2.5 meters. Determine the required value of the mass of the cylinder in kgs.

  Determine what is the stationing of the pt

A crest vertical curve and a horizontal curve on the same highway have the same design speed. The equal-tangent vertical curve connects a +3% initial grade with a +1% final grade and has a PVC at 101+78 and a PVT at 106+72

  How much can the company afford to spend per month

Wheeling-Pittsburgh Steel is investigating whether it should it should replace some of the basic oxygen furnace equipment now or wait to do it later. The cost later (i.e. 3 years from now) is estimated to be $1,700,000.

  What is the easiest way to solve for the 2 unknowns

Are either of the Ax or Jx forces relevant to finding the tension between H and J. If so, what is the easiest way to solve for those 2 unknowns.

  Determine the relative humidity using psychrometric chart

The wet bulb and dry bulb temperatures for humid atmospheric air (at 100 kPa) are measured to be 20 C and 25C respectively. Determine: a. using the psychrometric chart, the relative humidity  b. using the psychrometric chart, the humidity ratio

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd