What contour intervals will be drawn if a 50ft interval

Assignment Help Civil Engineering
Reference no: EM13545641

1.An area that varies in elevation from 463ft - 634ft is being mapped. What contour intervals will be drawn if a 50ft interval is used? Which lines are emphasized?

2.Two identical uniform boards, each of weight 40lb, are temporarily leaned against each other as shown. Knowing that the coefficient of static friction between all surfaces is 0.40, determine

(a) the largest magnitude of force P for which equilibrium will be maintained,

(b) the surface at wich motion will impend.

Reference no: EM13545641

Questions Cloud

When the pump operates the measured power draw is equivalent : A pump for a wastewater treatment plant has a motor with a nameplate rating of 20 HP. When the pump operates the measured power draw is equivalent to 15 HP. The pump operates 80% of the time.
At what ocean level h will the gate first open : When using an automatic level and rod to conduct differential leveling for construction grade control of a concrete wall, the first necessary step following set up of the level is to:
The only section remaining to be installed is a segment : A town is installing a new 10” main to carry drinking water. The only section remaining to be installed is a segment through the middle of town. However, the excavators discover an archaeological site. The town decides to split the main into two sect..
Determine the cop of the heat pump and rate : Refrigerant 134a enters the condenser of a residential heat pump at 800 kPa and 35 degrees celcius at a rate of 0.018 kg/s and leaves at 800 kPa as a saturated liquid. If the compressor consumes 1.2 kW of power, determine a) the COP of the heat pump ..
What contour intervals will be drawn if a 50ft interval : An area that varies in elevation from 463ft - 634ft is being mapped. What contour intervals will be drawn if a 50ft interval is used? Which lines are emphasized?
The mass center of the unbalanced disk of weight w is locate : The mass center of the unbalanced disk of weight W is located at G, which is a distance of R/2 from the center for the disk. In the equilibrium postition
What will be the discharge through the pipe : A pump having the characteristics given in figure 14.9 ( N=2133.5 rpm, n=35.6 rps, D=37.1 cm) pumps water at 25 degree C from a reservoir at an elevation of 366 m to a reservoir at an elevation
Find the operating points (q) for one pump : The pump curve for a given pump is represented by hp,pump=20 (1-(Q/100)^2) where hp,pump is the head provided by the pump in feet and Q is the discharge in gpm.
What is the minimum radius that can be cleared : A two lane hwy with 12' lanes is to be reconstructed to a design speed of 50 mph. Due to right of way restrictions, the largest distance that can be cleared from the edge of the road is 10'. What is the min. radius?

Reviews

Write a Review

Civil Engineering Questions & Answers

  Provide qualitative evluation of site as a basis for a phase

the weekly volume placed on the soil was 25% of the pore volume for the top 0.5m of soil. the soil is a clay loam characterized by an iron oxide content of 4.6% and 2,9% organic carbon.

  Derive a formula relating the variables of the tube

consider the steady viscous flow through a small horizontal tube. for this type of flow, the pressure gradient along the tube should be a function of the dynamic viscosity, the mean velocity and the diameter of the tube

  Find range of value of p for which equilibrium is maintained

a 300 lb block is supported by a rope that was wrapped 1 1/2 times around a horizontal rod. Knowing that the coefficient of static friction is .15 determine the range of values of P for which equilibrium is maintained

  Determine payback period for an asset that has a first cost

Determine the payback period for an asset that has a first cost of $40,000, a salvage value of $8000 anytime within 10 years of its purchase, and generates income of $6000 per year.

  How many tons of aggregate will be needed

The allowable stress in a steel shaft with an outside diameter of 1.5in and an inside diameter of 1.1in is 12,000psi. What hp can the shaft deliver at 1750rpm?

  Estimate the required volume of the aeration tank

A town is going to upgrade its primary WWTP to a secondary plant that can meet the effluent standard of 25 mg/L BOD5 and 30 mg/L suspended solids. They have selected a CSTR activated sludge system for the upgrade.

  Determine how much power will be required above sea level

If I raise a 1000 lbf weight 100 feet above sea level on earth in 10 seconds how much power will be required

  Determine the force and couple at o equivalent to the two

Head loss and sunshine striking a pipeline cause the temperature of the water flowing inside to rise by 2 degrees Celsius between two measuring points. Find the heat gain in J/N and cal/N.

  Explain important information about short essay

Important information about Short essay, In managing the uncertainties of ethical issues in engineering, what are some questions that we may ask to limit some of the risk

  Determine the total number of unit cells in the foil

aluminum foil used to package food is approximately 0.001 inch thick. assume that all of the unit cells of the aluminum are arranged so that a is perpendicular to the foil surface.

  Will the water flow up over the wall like water flows up

For a groundwater hydrology problem, if you have an unconfined aquifer, and someone inserts an impermeable wall into the middle of it (a wall that starts at the bottom and does not stretch the full height of the aquifer),

  Select beam dimensions nd reinforcement for balanced section

Select the beam dimensions and reinforcement for a balanced section if the beam sustains a moment as a result of dead load of 60 kip-ft and a moment as a result of live load of 90 kip-ft

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd