Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
An intercom system has a 13 kHz annoying whistle with amplitude of 20% of a typical voice signal. Assume that a typical voice signal has a frequency of 3 kHz and the intercom's output for a typical voice level has amplitude of 10V. How would my circuit look like? What should be my design and what component values are supposed to be used.
Calculate the smallest area of the RCS pf the target if the transmitters peak power is 1MW, frequency =10GHz, sensitivity ofthe receiver is -100dB/W, antenna gain is 50dB. Perform the calculation for the reference condition.
Experiment by changing the amplitudes of the modulating tones, and by adding a third tone to the modulating signal. First establish what you expect , then confirm by computer simulation.
This counter has an output"odd" whose value is 1 when the current count value isodd. Use the sequential design technique. Start from a state diagram, draw the state table, minimize the logic, and draw the final circuit.
A transmission line has the following per-unit-length parameters: L = 0.5 H/m, C = 200 pF/m, R = 4.0 /m, and G = 0.02 S/m. Calculate the propagation constant and characteristic impedance of this line at 800 MHz. If the line is 30 cm long
what size capacitor should be placed in series with the series combination of 800 ohms and 20mH to give an admittance whose magnitude is 1m/ohm at w=10k rads/s
explain the function of frequency dial and frequency range.
Design a combinational circuit that multiplies two 2-bit numbers, a1,a0 and b1,b0, to produced a 4-bit productc3,c2,c1,c0,. Use AND gates and half-adders.
Design a buck converter to produce an output voltage of 18 V across a 10- load resistor. The output voltage ripple must not exceed 0.5 percent. The dc supply is 48 V. Design for continuous inductor current.
If you have a purely inductive load with a reactance of 2/377 O connected to the 120Vrms 60 Hz (i.e., f = 377 rad/sec) AC line, what value of capacitor (in Farads) must be put in parallel with it to set the power factor to one
A square coil with sides of length 0.5m and of 100 turns of wire isplaced in a region with uniform magnetic flux density of 0.2T. If the maximum magnetictorque exerted on the coil is 4x10^-2 Nm , what is the current flowing in the coil
Two single phase transformers are connected in parallel with the following parameters. Transformer A, rated at 60 kVA Rc=250 k Ohm Req=25 Ohm Xm=45 k Ohm Xeq=150 Ohm
You are evaluating the feasibility of adding an injection molder to fabricate plastic sporks (everybody’s favorite harmless utensil) for the US Facility for the Criminally Insane. An injection molder will cost $1,200,000 installed.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd