What clock code is required and what is first null bandwidth

Assignment Help Electrical Engineering

Reference no: EM13288463

A DS-SS system requires 40 db of CW rejection of an interfering signal. it uses an 8-stage shift register m-sequence generator and transmits 1.5 kbps binary message data an a 2 GHz carrier. What clock code is required and what is the first null bandwidth?

Reference no: EM13288463

Questions Cloud

Define wedge-and-dash bonds for the substituent groups : Draw every stereoisomer for 1-bromo-2-chloro-1,2-difluorocyclopentane. Use wedge-and-dash bonds for the substituent groups, and be sure that they are drawn on the outside of the ring, adjacent to each other

Design a half-subtractor circuit with inputs x and y : a. design a half-subtractor circuit with inputs x and y and outputs Diff and B out. the circuit subracts the bits x - y and places thedifference in Diff and the borrow in B out. b. design a full- subtractor circuit with three inputs x,y,B in andtwo..

Define and write a balanced equation for the reaction : Write a balanced equation for this reaction. How many grams of iron are required to make 2.50 L of aqueous solution containing 8.00 % Iron (III) chloride by mass. The density of the solution is 1.067g/mL

Determine the maximum number of hopping frequencies : An FH-BPSK signal modulated with 6kbps data has a spectrum bandwidth of 20 MHz. the BPSK signal is filtered allowing only two spectral components on either side of the carrier find the maximum number of hopping frequencies.

What clock code is required and what is first null bandwidth : A DS-SS system requires 40 db of CW rejection of an interfering signal. it uses an 8-stage shift register m-sequence generator and transmits 1.5 kbps binary message data an a 2 GHz carrier. What clock code is required and what is the first null ba..

Determine what step should the code be set to : A spread spectrum system has a code rate that can be switched from 500 kbps to 1.5 Mbps in 100 k steps. If the message rate is 1.3 kbps and the processing gain is 1050. What step should the code be set to

Design logic circuit to control electrical power to engine : Design a logic circuit to control electrical power to the engine ignition of a speed boat. Logic output I is to becomehigh if ignition power is to be applied and is to remain lowotherwise. Gasoline fumes in the engine compartment present aserious ..

Explain wedge-and-dash bonds for the substituent groups : Use wedge-and-dash bonds for the substituent groups, and be sure that they are drawn on the outside of the ring, adjacent to each other

Determine the normalized impedance from the load : Determine the normalized impedance at λ/8 from the load if (a) its normalized impedance is 2 +j, (b) its normalized admittance is 0.2 - j0.5, (c) the reflection coefficient at load is0.3 + j0.4.

User Account

All Pages