What are the temperature and pressure at the nozzle exit

Assignment Help Mechanical Engineering

Reference no: EM13710309

Room temperature atmospheric air is accelerated by a nozzle steadily from a low velocity to a velocity of 220 m/s. If the nozzle diameter decreases by a factor of 2:

a. What is the inlet velocity of the air?

b. What is the enthalpy change during the process?

c. What are the temperature and pressure at the nozzle exit?

Notes: Assume room temperature specific heats

Reference no: EM13710309

Questions Cloud

Hot water is provided to a house by an electric water heater : Hot water is provided to a house by an electric water heater which uses a 60L tank. The electric heater is rated for a 1.6kW. The hot water tank is completely full with water at 80°C when someone starts a shower. The shower faucet mixes cold water at..

Saturated water vapor is contained in a rigid container : Saturated water vapor is contained in a rigid container. Heat is then added until the the pressure and temperature become 812.075 MPa and 400 °C, respectively. What was the initial temperature of the steam in °C?

Separation of variables method to the schrodinger equation : Apply the separation of variables method to the Schrodinger equation for the hydrogen atom in spherical coordinates. The solutions for the three ordinary differential equations obtained in step 1 should be found in a Math textbook. Please make sure t..

What is the value of maximum stress and nominal stress : A circular rod with a diameter of 32.4mm has a groove cut to a diameter of 27mm. A full radius of 2.97mm is produced at the bottom of the groove. Compute the maximum stress in the rod when an axial tensile force of 42kN is applied.

What are the temperature and pressure at the nozzle exit : Room temperature atmospheric air is accelerated by a nozzle steadily from a low velocity to a velocity of 220 m/s. If the nozzle diameter decreases by a factor of 2:

Pressure difference between the inlet and the test section : A water filled manometer is attached to the inlet and the test section of a low speed wind tunnel which has the contraction ratio of 3. what would be the pressure difference between the inlet and the test section in terms of inches of water in order ..

Living plant leaf is an open system that exchanges energy : A living plant leaf is an open system that exchanges energy (sunlight and thermal flows) + matter (O2, CO2, water vapor, etc.) with the surroundings (the exterior). Even with irreversible processes (energy dissipation) we find that the net entropy ch..

Refrigerant is saturated at the inlet to the compressor : A vapor compression refrigeration cycle using R-134a as the working fluid has an evaporator temperature of -20Â°F, and a condenser pressure of 140 psia. The refrigerant is saturated at the inlet to the compressor and at the exit of the condenser. The..

Steam turbine operating at steady state produces : A steam turbine operating at steady state produces 6,000 hp with a heat transfer to the surroundings at a rate of 360,000 Btu/hr. Steam enters at 600 F, at 200 psi and exits as a saturated vapor at 8 psi. Neglecting the KE and PE determine the volume..

User Account

All Pages