What are the normal stresses in the bars afterward

Reference no: EM13540136

Two aluminium bars (E = 70 GPa) are attached to regid support at the left and a cross-bar at the end. An iron bar (E = 200 GPa) is at attached to the rigid support at the left and there is a gap b = 0.6 mm between the right end of the iron bar and cross-bar. The cross sectional area of each bar is A = 400 mm2 and L = 250 mm. If the cross bar is loaded with a load P = 250 kN, what are the normal stresses in the bars afterward?

Reference no: EM13540136

Questions Cloud

How fast will the sleeve slide down the rod : A sleeve 30 cm long encases a vertical rod 2.5 cm in diameter with uniform radial clearance of 0.005 cm. when the sleeve and the rod are immersed in a pool of oil with dynamic viscosity

Select the required commercial size of the rod required to : Two forces are applied as shown to hook support. Knowing that the magnitude of P is 35 N, determine by trigonometry (a) the required angle a if the resultant R of the two forces applied to the support is to be horizontal, (b) the corresponding magnit..

Is this level dangerous to the fish population : A lake has a volume of 750,000 m3 (dimensions 15 m deep, 100 m wide, and 500 m long) and behaves as two completly mixed cells. Cell 1 makes up 40% of the lake ( dimensions 15 m deep, 100 m wide, and 200 m long) cell 2 makes up 60% of the lake (dimens..

Computer the percent voids in total mix : An aggregate blend is composed of 53% coarse aggregate by weight (sp. gr. 2.702), 43% fine aggregate (sp. gr. 2.621), and 4% filler (sp. gr. 2.779)/ The compacted specimen contains 6% asphalt binder (sp. gr. 1.052) by weight of total mix, and has a b..

What are the normal stresses in the bars afterward : Two aluminium bars (E = 70 GPa) are attached to regid support at the left and a cross-bar at the end. An iron bar (E = 200 GPa) is at attached to the rigid support at the left and there is a gap b = 0.6 mm between the right end of the iron bar and cr..

If the bearing stress on the concrete pedestal must not : If the allowable stress in the cylinder is 55 MPa, what is the maximum internal diameter (nearest integer, such as 10, 11, 12, …., in units of millimetres) of the cylinder?

Describe how you analysed and defined a problem : Describe how you analysed and defined a problem and identified the engineering knowledge and skills required for solving the problem?

What are the normal stresses in the bars afterward : The cross sectional area of each bar is A = 400 mm2 and L = 250 mm. If the cross bar is loaded with a load P = 250 kN, what are the normal stresses in the bars afterward?

Compute the required weight of the aggregate per cubic yard : Concrete mix with a 3 in slump, w/c ratio of .5, and sand with a fineness modulus of 2.4 contains 1700 lb of coarse aggregate.

User Account

All Pages