Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A silicon sample is 85x10^-6 m in length and has a cross-section of 20x10^-6 m x 6x10^-6 m. It has been uniformly doped with Arsenic with a doping density of 4.5x10^15 cm^-3. Assume the temperature is 300K and mobilities are u_n = 1300 cm^2/Vs and u_p = 450 cm^2/Vs.
a. What are the majority and minority carrier concentrations?
b. What is the resistivity of the sample?
c. What is the resistance (end-to-end) of the sample?
1. What parameter of the intelligence signal causes or determines the rate of carrier frequency deviation 2. If you are tuned to an FM station at a frequency of 100.1 MHz, show the bandwidth allocation for two adjacent stations.
Determine the cost of the energy delivered by this battery per kilowatt hour. Compare to the $0.12 per kilowatt hour for energy purchased from electric utilities in the United States.
Light is incident from air to glass at Brewster's angle. Determine the incident and transmitted angles. Glass has refractive index n2=1.45.
draw a digital design consisting of 2 input AND gates and three inverters, where an inverter is connected to each of the AND gates input and its output. For each of the four possible combinations inputs applied to the two primary inputs.
(1) If you have a transformer that is not in a circuit, how can you tell/determine what the ratio is (2) How do you tell if a diode is forward or bias. How much voltage is assumed dropped across a forward biased silicon diode.
Air is to be compressed from atmospheric pressure at 60oF to 100 psia in a centrfugal compressor (isentropic efficiency about 0.7). The flow rate will be 500 lbm/min. Specify the horsepower required for the driving motor
Whether reading consecutive 20 bits from the same wordline would consume about 20 times more energy than reading 1 bit from this wordline. What is the total storage capacity of this DRAM array
A 1.80kg , horizontal, uniform tray is attached to a vertical ideal spring of force constant 195N/m and a 290g metal ball is in the tray. The spring is below the tray, so it can oscillate up-and-down.
Design limiter circuits using only diodes and 10-k ohm resistors to provide an output signal limited to the range: (a) -0.7V and above (b) -2.1V and above (c) ±1.4V Assume that each diode has a 0.7-V drop when conducting.
The input impedance of a 31cm long lossless transmission line of unknown characteristic impedance was measured at 1 MHz. With the line terminated in a short circuit, the measurement yielded an input impedance equivalent
A nickel-iron ring withcross-sectional area 0.85cm2 is expected to be driven to itssatur-ation magnetization of 1.1T in a ?eld of 800 A/m. The ?ux density will be measured by an electronic ?ux integrator with input resistance of 1kOhm
Each window and door has a switch attached such that the contacts close when a door or window opens. Draw a ladder logic diagram that will turn on a light if one or more windows are open or if both doors are open.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd