Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1. Suppose a convergent-divergent nozzle is operated as case h in Fig. 15.17. What kind of nozzle could have the same exit pressure, but with a reversible flow?
2. A stationary thermometer measures 80?C in an air flow that has a velocity of 200 m/s. What is the actual flow temperature?
3. Steam leaves a nozzle with a pressure of 500 kPa, a temperature of 350?C, and a velocity of 250 m/s. What are the isentropic stagnation pressure and temperature?
A steady flow of refrigerant 134a enters a throttling valve in a refrigeration unit as a satrurated liquid with a pressure of 150 psia. The refrigerant is discharged with a pressure of 40 psia.
air enters a turbine operating at steady state at 8 bar, 1127 C and exits at 1.5 bar, 347 C. The heat transfer from the turbine to its surroundings is 10 kJ/kg of air flowing through the turbine.
Divide the resulting time histories into 10 equal segments and identify the median peak value for each area and for each wind direction. Identify the locations of the worst--case values and wind directions.
The pulleys attached to the shaft are loaded as shown. If the bearings at A and B exert only horizontal and vertical forces on the shaft, determine the required diameter of the shaft to the nearest 1/8 in. using the maximum-shear-stress theory of fa..
Base course aggregate has a target dry density 119.7 lb/cu ft in place. it will be laid down and compacted in a rectangular street repair area of 2000 ft x 48 ft x 6 in the aggregate in the stockpile contains 3.1% moisture.
A small stream of 20,000 cfm has a BOD of 5 mg/L. An industrial outfall joins the stream; the outfall has a BOD of 250 mg/L. Downstream of the outfall, the BOD must be 10 mg/L to meet regulations. What is the allowable flow rate of the outfall in ..
How to design a simply supported rectangular concrete beam havingcross section of 20 mm by 40 mm and a length of 3 meters that couldcarry a uniform load of 1000 KN.
The total system is insulated, so there is no heat transfer to or from the ambient. Find the final state, the work given out to the piston, and the total work to or from the heat engines/pumps.
what is the procedure to design the beam and column?
If the coefficient or restitution is e = 0.1, express the speeds υA and υB of the two cars at the end of the impact in terms of p and v. Evaluate your expressions for p = 0.5.
Determine the force in each member of the scissors truss shown in Figure 2. State the whether the members are in tension or compression. The reactions at the supports are given.
The coefficients of kinetic friction between the blocks and the inclined plane are a=0.1,b=0.3. Neglect the mass of the link. Angle between the inclined plane and the surface is 30 degree.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd