What are the internal loads supported at the shoulders

Assignment Help Civil Engineering
Reference no: EM131198674

This 140 lb gymnast supports himself with arms stretched out in the iron-cross position shown. Say the arms each weigh 10% of the body weight (and have approximately uniform distribution of mass), and that each ring exerts only an upward force on each hand. What are the internal loads supported at the shoulders?

1618_f5466c40-b532-488c-b095-fe5a7a6cbb19.png

Reference no: EM131198674

Questions Cloud

Prevent optical damage to the windows of the cell : what is the minimum value of the laser pulse energy per unit area that can be used to excite SBS? (SBS is often excited by tightly focused laser beams rather than by collimated beams to prevent optical damage to the windows of the cell
What types of variances are found on cost center reports : Explain how exception reporting would be invaluable to the manager of a credit department.- What types of variances are found on cost center reports?
Describe responsibility for a chief financial officer : FIN200 Assignment Questions. List and briefly describe the three general areas of responsibility for a chief financial officer (CFO) of a selected non-financial company which is listed on Australian Stock Exchange (ASX)
Investigate volkswagen performance : Using a search engine of your own choosing, investigate Volkswagen's performance over the past two years. Write a brief summary of their fortunes and misfortunes.
What are the internal loads supported at the shoulders : This 140 lb gymnast supports himself with arms stretched out in the iron-cross position shown. Say the arms each weigh 10% of the body weight (and have approximately uniform distribution of mass), and that each ring exerts only an upward force on ..
Explain the concepts of information systems security : Describe how malicious attacks, threats, and vulnerabilities impact an IT infrastructure. Explain the means attackers use to compromise systems and networks, and defenses used by organizations. Explain the role of access controls in implementing a se..
Under what conditions will revenue rise fall or remain same : Suppose that, in an attempt to raise more revenue, Nobody State University increases its tuition. Will this necessarily result in more revenue? Under what conditions will revenue (a) rise, (b) fall, or (c) remain the same?
How large a wozac plant the company should build : Determine how large a Wozac plant the company should build to maximize its expected profit over the next 10 years.
What thrust p must each tug exert on the ship : Each propeller of the twin-screw ship develops a full speed thrust of 300 kN. In maneuvering the ship, one propeller is turning full speed ahead and the other full speed in reverse. What thrust P must each tug exert on the ship to counteract the e..

Reviews

Write a Review

Civil Engineering Questions & Answers

  How to design for a two-lane road in mountainous terrain

A horizontal curve is to be designed for a two-lane road in mountainous terrain. The following data are known: intersection angle: 50 degrees, tangent length: 400 ft, station of PI: 2000+00, e: .08, fs:.16

  Determine the required diameter of the thread

A nylon thread is to be subjected to a 10-N tension. Knowing that E=3.2 GPa, that the maximum allowable normal stress is 40 MPA, and that the length of the thread must not increase by more than 1%

  Find the cooling load for a room supplied with cfm

Find the cooling load (in tons of refrigeration) for a room supplied with 10,000 CFM of 95 DB outside air with ratio of 105 gr/lb. The room is to be maintained at 78 DB and humidity ratio of 71.5 gr/lb.

  Determine the tsp emission rate of the power plant

On a clear summer afternoon with a wind speed of 3.20 m/s measured at 100 m elevation, the TSP (total suspended solids) concentration was found to be 1520 ug / m3 at a point 2 km downwind

  A hollow rectangular masonry pier 600mm900mm and 150mm

a hollow rectangular masonry pier 600mm900mm and 150mm thick transmits a vertical load of 500knnbspin a vertical plane

  Determine what is the pressure acting on the sand

A 3-ft diameter column with weight of 150 kg is placed on top of 1 m thick aggregate layer. The soil beneath the aggregate layer is sand. The friction angle of the aggregate is 36 degrees and the unit weight is 22 lb/ft3. What is the pressure acti..

  What amount of tension do you need to apply not to have any

You are using that tape to measure the distance between two pointswhere the tapes are supported at the ends only. The temperature ofthe day is 68oF. What amount of tension do you need to apply not tohave any corrections in the tape measurement?

  Prepare pulpwood chips for paper making

A four-cylinder industrial engine runs at 2200 rpm and delivers 75 hp to the input gear of a drive for a large wood chipper used to prepare pulpwood chips for paper making. The output gear must run between 4500 and 4600 rpm.

  Define the term safe bearing capacity as used in foundation

Define the term safe bearing capacity as used in foundation

  What is the efficiency of the device

If a mechanical device requires 450J of work to do 310J of work in lifting what is the efficiency of the device?

  What is the detention time in the cstr

Assume the overall system is at steady-state, theflow rate is 15 L/min, the detention time is the PFR is 1.5 hours,and the decay rate of compound A is defined by a first-order ratereaction (k = 1 h-1).

  Determine the flying height of the camera at the time

Using photo coordinates for points 4 and GYM on image 5, determine the flying height of the camera at the time of exposure.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd