What are the inputs needed to determine stress a polymer

Reference no: EM13546695

1.Calculate the section modulus for a 6 in by 10 in (S4S) timber cross section, with respect to the strong axis.

2.Determine the dimensions for a square concrete pad footing to suit the bearing capacity of 100kPa with a factor of safety 2.4

3.What are the inputs needed to determine stress a polymer with a fixed end on one side, and the other with a tension force of 50,000 lbs a year after the load is applied?

Reference no: EM13546695

Questions Cloud

How the equation for splitting tensile strength of a concret : Need to know how the equation for splitting tensile strength of a concrete cylinder f(ct) = 2P/pi*D*L is derived using mechanics of materials or linear elasticity approach.

What is the optimal number of orders per year : What is the average inventory if the EOQ is used, what is the optimal number of orders per year

Find the centroid for the cone : A single-scoop ice cream cone is a composite body made from a single scoop of ice cream placed into a cone. (Part B 1 figure) Assume that the scoop of ice cream is a sphere with radius r = 1.67

Prepare consolidation workpapers for par corporation : Prepare consolidation workpapers for Par Corporation and Sol for the year ended December 31, 2011. Use an unamortized excessaccount.

What are the inputs needed to determine stress a polymer : What are the inputs needed to determine stress a polymer with a fixed end on one side, and the other with a tension force of 50,000 lbs a year after the load is applied?

Compute the maximum horizontal shear stress at the neutral : A solid rectangular simply supported timber beam 6 in wide, 20 in deep, and 10 ft long carries a concentrated load of 16,000 lb at midspan. Use nominal dimensions.

Estimate the settlement of the footing four years after : A proposed square footing 2 meters by 2 meters carrying a total load of 800 kN is to be constructed on a sand deposit. The depth of the footing will be 1 meter below the ground surface

Prepare the t-accounts and journal entries : Prepare the T-accounts for raw materials inventory, work in process inventory, finished goods inventory, manufacturing overhead, and cost of goods sold. Don't forget to enter the beginning balances in the inventory accounts.

The pump is located close to the pipe entrance at the lower : Water from a lower reservoir (water surface elevation) 500 m is pumping to the upper reservoir (water surface elevation 600 m) through a 5000 m long straight pipe with 0.5 m diameter

User Account

All Pages