What are the density volume-to-capacity ratio and level

Assignment Help Civil Engineering

Reference no: EM13564989

A 5% upgrade on a six-lane freeway (three lanes in each direction) is 1.25 mi long. On this segment of freeway, the directional peak-hour volume is 3800 vehicles with 2% large trucks and 4% buses (no recreational vehicles), the peak-hour factor is 0.90, and all drivers are regular users. The lanes are 12 ft wide, there are no lateral obstructions within 10 ft of the roadway, and the total ramp density is 1.0 ramps per mile. A bus strike will eliminate all bus traffic, but it is estimated that for each bus removed from the roadway, seven additional passenger vehicles will be added as travelers seek other means of travel. What are the density, volume-to-capacity ratio, and level of service of the upgrade segment before and after the bus strike?

Reference no: EM13564989

Questions Cloud

Will the vc meet minimum ssd standards if speeds can : A particular crest vertical curve (VC) on US 280 at Shelton Mill Rd has long been criticized as being unsafe. Its length is 400 feet. The prevailing speed on the crest VC is 50 mph

Determine the maximum possible flame temperature : Consider your cooking gas contains 80% propane and 20% butane. While burning on a cooktop, assume it burns with 200% excess air. If no heat is lost, determine the maximum possible flame temperature.

Find the coefficient of permeability of the clay for : A laboratory consolidation test was performed on a clayey soil specimen, which was drained on both top and bottom. The time for 50% consolidation was 6.2 minutes, and the specimen's thickness at 50% consolidation

Compute the amount of primary consolidation settlement that : A compressible 12-ft clay layer beneath a building is overlain by a stratum of sand and gravel and underlain by impermeable bedrock. The total expected primary consolidation settlement of the compressible clay layer due to the building load is 4.60 i..

What are the density volume-to-capacity ratio and level : A 5% upgrade on a six-lane freeway (three lanes in each direction) is 1.25 mi long. On this segment of freeway, the directional peak-hour volume is 3800 vehicles with 2% large trucks and 4% buses (no recreational vehicles), the peak-hour factor is 0...

How much heat had to be transferred to the vessel : Alkaloids are chemical compounds containing nitrogen that can be produced by plant cells. In an experiment, an insulated closed vessel 1.673 m3 in volume was injected with a dilute water solution containing two alkaloids: ajmalicine and serpentine.

Calculate the axial strain and the transverse strain in the : A rigid rectangular shelf is suspended from a rigid ceiling by mean of four rods of diameter .505 inches. The two rods to the left L1 and L2, are made of steel

What is the stress along the top edge and the bottom edge : A horizontal pre-stressing force of 500kN is applied to rectangler beam. the beam has a depth of 500mm and a width of 250mm. the force is applied at a distance of 80mm below the x-x axis. what is the stress along the top edge and the bottom edge caus..

What is the maximum column load in kips that could be placed : What is the maximum column load in kips that could be placed on a 4-ft square temporary footing on a sand for which the standard resistance is about N=15 and the water table is at the surface? A factor of safety of 2 is to be maintained against beari..

User Account

All Pages