Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1- what is meant by plug and ply devices? what are the bus protocols that support plug and play devices?2- what is hot attachment and detachment? what are the bus protocols that support hot attachment and detachment?3- what is a timer? how does a counter perform (a) timer functions, (b) prefixed time initiated events generation and (c) time capture functions?4- why do you need at least one timer device in an embedded system?
A circular polarized wave in air is incident on glass surface. The angle of incidence equals the Brewster angle. Refractive index of glass, n(glass) is 1.35. Find the following quantities 1) The Brewster angle. 2) The angle of refraction
The acceptor concentration in a particular junction is 10^6/cm^3 and the donor concentration is 10^15/cm^3. Assume ni=1.5*10^10/cm^3. Find the junction built-in voltage.
Write the VHDL ARCHITECTURE file for the Y(5) output only for a 8-to-1 demultiplexer. The inputs are D, the selects S0-S2, and the outputs Y(0)-Y(7). The select lines are BIT_VECTOR types, the data is BIT type and the outputs are BIT_VECTOR types.
A pn junction may be formed by depositing a single crystal film of uniformly doped p-silicon onto a substrate that has been doped n-type. The substrate is 500um thick, and the film is 20um thick. The substrate has a 5 ohm-cm resistivity.
Determine the capacitance required in a half wave rectifier to produce a ripple voltage less than 0.2V. Assume that the input is a 60Hz signal with maximum voltage VM=100V
Suppose that you wish to offer a voice over IP wireless service. The target packet error rate (or drop rate) is 10^3 and you determine that if the signal is confined to within a coherence band, about 20% of the packets are dropped due to fading.
give the definition of electrical circuit. draw the simplest electrical circuit and mark the directions of electrical values in it and ohms law. what are the main and the additional elements of the electrical circuit and that are the purpose.
Imagine a network layer packet that travels from one host to another host across multiple local area networks interconnected by routers, Explain how the packet moves from device to device through the network.
calculate the short-circuit current of a three-phase delta-wye connected transformer if the short circuit occurs between phase A and the neutral at the low voltage side, and the transformer is supplied by a 13 kV line-to-line voltage.
An input signal of 10V at 0o and a frequency of 1592 Hz is applied to a parallel RC circuit with resistor R = 100 ohm and capacitor C = 1 F. what is The source current.
Find the final yield for a nine-mask-level process in which the average fatal defect density per cm2 is 0.1 for four levels, 0.25 for four levels, and 1.0 for one level. The chip area is 50 mm2.
What is the sample period Ts?
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd