Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
One of the firm's suppliers discounts prices for larger quantities. The first 1000 parts are $13 each. The next 2000 are $12 each. All parts in excess of 3000 cost $11 each. What are the average cost and marginal cost per part for the following quantities.A. 500B.1500C.2500D.3500
Design an elevator controller for a simple two-floor elevator. On the 1st floor, there is only an up button, and on the 2nd floor, there is only a down button. Within the elevator, there are two buttons: door open and door close.
Data at a rate of 2 Mbps is to be transmitted via a pass-band communication system whose carrier frequency is 500MHz. A binary antipodal system with roll-off factor of 0.2 is used for this communication.
(a) Convert the expression for f(x, y, z) = fm(1, 3, 7) from minterm list from to maxterm list form. (b) Convert the expression for f(a, b, c, d) = fM(0, 1, 2, 3, 4, 6, 12) from maxterm list from to minterm list form.
Discuss some key characteristics of "load lines". What information does a load line provide you. Discuss key quantities from a zener diode data sheet. What are most important for a circuit designer.
A differential equation of a system with x(t) as an input and y(t) as an output is defined as a.)Find the system response to unit step function, x(t)= u(t), where b.) Specify the Zero Input Response.
It was noticed (in the field) that when the load was turned off (0 real power consumption) that the generator began to operate leading, yet the engineer was not able to replicate this behavior using the model described above. Explain what is defic..
Find the final yield for a nine-mask-level process in which the average fatal defect density per cm2 is 0.1 for four levels, 0.25 for four levels, and 1.0 for one level. The chip area is 50 mm2.
The balanced 60Hz waveform sample that we must modulate is the point where t=4.4ms. The DC voltage from rail to rail is 300V. assume the q axis and a axis are in same direction. The use of mathCAD is recommended.
The total charge that has accumulated on the positive plate of a capacitor varies with time. The charge follows q=At^2 for the first 4s. a) Find the value of current at t=2,6,9,12,16 s. b) Sketch the current i(t) as a function of time
Find the minimal sum and distinguished 1-cell using Karnaugh Maps for the following functions, also state essential prime implicants (if any) and which are non-essential prime implicants (if any) a. F = fA,B,C,D (2,,4,6,7,12,13,14,15)
Design a hand warmer with a heated element consisting of an encapsulated resistor to be held in your hand and powered by a 6V battery that you put in your coat pocket. Use 26 gauge wire to connect the resistor to the battery.
a beam of polarized light of intesity I0 passes through a sheet of ideal polarizing material. The polarization axis of the beam and the transmission axis of the sheet differ by 30 degrees. What is the intensity of emerging light
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd