What are some of the uses of adc undersampling

Assignment Help Electrical Engineering
Reference no: EM13227094

1. When no analog filter is used at the input, why does an input of 1032 and 4960 Hz produce an output frequency of nearly 50 Hz? Keep in mind that the sampling frequency of the filter is 982 Hz. Justify your answer using the necessary formula.

2. What are some of the uses of ADC undersampling (i.e., sampling at a rate lower than Nyquist rate)? Research this topic using the Internet, but state the answer in your own words.

3. Suppose we had connected at the input to channel 0 a circuit of the type that attenuates all frequencies above 50 Hz at a rate of 6 dB/octave. What will we then see in the output when we apply 4960 Hz at the input?

Reference no: EM13227094

Questions Cloud

Compute the percent cu and ni in the alloy : Mercaptoacetic acid and NH3 were introduced, production of the complex with the former resulted in the release of an equivalent amount of EDTA, which required a 22.85-mL titration with 0.07238 M Mg2+. Calculate the percent Cu and Ni in the alloy.
Describe the value chain of your case study company : What are the merits of outsourcing the performance of certain value chain activities as opposed to performing them in-house? Under what circumstances does outsourcing make good strategic sense? Describe the value chain of your case study company.
What are the risks and disadvantages of such alliances : What are the risks and disadvantages of such alliances? What strategic alliances does your case study company employ?
Identify and explain the meaning and strategic significance : What is the strategy of your case study company? Identify and explain the meaning and strategic significance of each of the following terms
What are some of the uses of adc undersampling : Suppose we had connected at the input to channel 0 a circuit of the type that attenuates all frequencies above 50 Hz at a rate of 6 dB/octave. What will we then see in the output when we apply 4960 Hz at the input
What does case study company do to ensure ethical compliance : Does a company have a duty to go beyond legal requirements and conform to the ethical norms of the societies in which it operates? What is the case for why business strategies should be ethical? What does your case study company do to ensure ethic..
Find the probability of error in digital communication : A digital communication system transmits one of the three values -1,0,1. A channel adds noise to cause the decoder to sometimes make an error. The error rates are 12.5% if a -1 is transmitted, 75% if a 0 is transmitted, and 12.5% if a 1 is transmi..
Explain what is involved in building capabilities internally : Explain what is involved in building capabilities internally? What steps are required? How much time does it take? How hard is it? Support your answer. How does your case study company do this?
Discuss the type of control mechanisms that managers can use : Discuss the type of control mechanisms that managers can use to monitor the performance of empowered employees. Apply this question to your case study company.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Why can''t a video signal such as an ntsc analog television

Why can't a video signal such as an NTSC analog television signal be transmitted over a two km length of loaded twisted pair cable with a frequency range 300 Hz to 3,400 Hz? What is the bandwidth occupied by an NTSC video signal?

  Design a 4-bit binary incrementer using half-adders

Design a 4-bit binary incrementer using HALF-ADDERS as building blocks. The circuits implements A+1=S where A and S are 4-bit binary numbrers. The circuit has 4 inputs A3A2A1A0 and 5 outputs : S3S2S1S0 and overflow C4. Draw the circuit diagram wit..

  What is the net resistance of the cone from top to bottom

A truncated cone has a height of 50cm. The circular faces on the top and bottom have radii of 20 mm and 1mm, respectively. If the material from which the solid cone is constructed has a conductivity sigma of 2 x 10^6 S/m.

  How much power is dissipated by the source

In a typical AC circuit, the supply voltage is 10 VPK and frequency is 60 Hz. If the current through the system is 2 APK with a phase angle of 60o, then the power dissipated by the source is

  How fast can a telephone channel carry data

Telephone channels have a bandwidth of about 3.1khz. do the following in excel. A) If a telephone channel signal to noise ratio is 1000, how fast can a telephone channel carry data?

  What is the maximum volume in liters of carbon dioxide

The following equation represents the complete combustion of ethane: 2C2H6(g) + 7O2(g) 4CO2(g) + 6H2O(g)At the same temperature and pressure what is the maximum volume in liters of carbon dioxide

  How receiving end maintains a constant load power factor

The SV curve can be used to understand the impact of constant power factor shunt compensation support. In this case, the receiving end is injected with a specific amount of reactive power so that the receiving end maintains a constant load power f..

  Explain tuning methods for pid controllers

Tuning methods for PID controllers, Investigating tuning methods for PID controllers of 2nd order and 3rd order control systems. Eg. Zieglar Nichols, etc

  Find an xc value to put in parallel with the motor

A P=900W electric motor with pf=0.82 lagging is connected to a 240 Vrms 60 hertz source. a) Draw an equivalent circuit showing impedance and phasor values for Vs, R and X. b) Find an Xc value to put in parallel with the motor which corrects the pf to..

  What is the minimum donor doping required

What is the minimum donor doping required to convert Silicon into a conductor? What is the minimum acceptor doping required to convert Silicon into a conductor?

  Explain what is the resolution of each quantizer

Supply the quantisation levels (including zero) that are available. Do this for both the three and 4-bit ADC in table form. What is the resolution of each quantizer?

  What is the rms value of the current through the capacitor

a 10uF capacitor is plugged into a 110v rms 60 hz voltage source with an ammeter in series. what is the rms value of the current through the capacitor?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd