What are its density specific weight and specific gravity

Assignment Help Civil Engineering

Reference no: EM13539034

1.The 10mm diameter rod is made of Kevlar 49. Determine the change in length and the change in diameter.

Lenght of the rod = 100mm

Therefore there are two 80KN forces are pulling the rod from both sides.

2.A 5 m3 volume of fluid weighs 50 kN. What are its density, specific weight, and specific gravity?

Reference no: EM13539034

Questions Cloud

Explain how you would prepare solutions from the dry solute : Describe how you would prepare the following solutions from the dry solute and solvent. 1.00*10^2g of .500m KCl

How would you explain the value of financial planning : How would you explain the value of financial planning to friends or family?

Calculate the length of side ut and the area of the plot : An engineer is required to survey a nonrectangular plot of land but is unable to measure side UT directly (see Figure 2.11). The following data are taken: RU=130.0m, RS=120.0m, ST=90.0m, angle RST= 115 degrees, and angle RUT= 100 degrees.Calculate th..

Calculate what is the total work done on the crate : A factory worker pushes a 31.4kg crate a distance of 4.35m along a level floor at constant velocity by pushing downward at an angle of 30.3 degrees below the horizontal. What is the total work done on the crate

What are its density specific weight and specific gravity : The 10mm diameter rod is made of Kevlar 49. Determine the change in length and the change in diameter.

Teaching net present value (npv) & future value (fv) : Teaching Net Present Value (NPV) & Future Value (FV)

Find out the ratio of volumes avogadro"s number : Determine the ratio of volumes (cm^3/atom and cm^3/mol) to determine Avogadro"s number (atoms/mole).

What is the full name of the daughter atom : the transmutation reaction 194Po -> 33Al + ___ + 31n, What is the full name of the daughter atom

Determine the modulus of elasticity and the poison ratio : A tensile load of 50 000 lb is applied to a metal bar with a 0.6x0.6 in cross section and a gage length of 2 in. Under this load the bar elastically deforms so that the gae length increases to 2.007 in

User Account

All Pages