Water filled manometer is attached to the inlet

Assignment Help Mechanical Engineering

Reference no: EM13712233

A water filled manometer is attached to the inlet and the test section of a low speed wind tunnel which has the contraction ratio of 3. what would be the pressure difference between the inlet and the test section in terms of inches of water in order to maintain the dynamic pressure of 20lb/ft^2 at the test section? Density of air = 0.00237slug/ft^3 and density of water = 1.94 slug/ft^3 , g=32.2ft/sec^2

Reference no: EM13712233

Questions Cloud

Determine the rate of net energy loss of the house : A house is maintained at 1 atm and 24 C, and warm air inside a house is forced to leave the house at a rate of 150m 3/h as a result of outdoor air at 5 C infiltrating into the house through the cracks. Determine the rate of net energy loss of the h..

Volume flow rate of the refrigerant at the compressor inlet : Refrigerant-134a enters an adiabatic compressor as saturated vapor at -24 degrees Celsius and leaves at 0.8 Mpa and 60 degrees Celsius. The mass flow rate of the refrigerant is 1.2 kg/s. Determine (a) the power input to the compressor and (b) the vol..

Surface equal three atmospheres of pressure : Atmospheric pressure at sea level is 14.7 psi. At what depth does the pressure of sea water plus the pressure of the air at the surface equal three atmospheres of pressure?

Flow around a model of a turbine blade is investigated : The flow around a model of a turbine blade is investigated. The model is five times larger than the prototype. A maximum pressure of 4 psi is measured at the leading edge, a maximum velocity of fps is measured near the top of the blade, and a small d..

Water filled manometer is attached to the inlet : A water filled manometer is attached to the inlet and the test section of a low speed wind tunnel which has the contraction ratio of 3. what would be the pressure difference between the inlet and the test section in terms of inches of water in order ..

How do they fit within the situational crime prevention : What are the countermeasures to those threats, and how do they fit within the Situational Crime Prevention framework - how does the current law help or hinder your countermeasures? Are there any proposals for laws that would assist?

Magnitude of force transmitted to module through isolator : An electronic control system for an automobile engine is to be mounted on top of the fender inside the engine compartment. It is desirable to isolate the module from the vibration induced in the car by road and engine vibration. Design an isolator (i..

Determine the final mixture temperature : A 0.9-m3 rigid tank is divided into two equal compartments by a partition. One compartment contains Ne at 0C and 100 kPa, and the other compartment contains Ar at 50 C and 200 kPa. Now the partition is removed, and the two gases are allowed to mix. H..

Logarithm stress versus logarithm rupture lifetime plot : Estimate the rupture lifetime (in hrs) for some cylindrical component originally 10.5 mm in diameter and 496 mm long that is fabricated from a low carbon-nickel alloy; assume that it is to be exposed to a tensile load of 6300 N at 538°C. The logarith..

User Account

All Pages