Volcano has erupted-spewing stones-steam

Assignment Help Mechanical Engineering
Reference no: EM13709587

A volcano has erupted, spewing stones, steam, and ash several thousand feet into the atmosphere. After some time, the particles begin to settle to the ground. Consider a nearly spherical ash particle that is 50 microns in diameter, falling in air whose temperature is -50°C and whose pressure is 55 kPa. The density of the particle is 1240 kg/m3. Estimate the terminal velocity of this particle at this altitude.

Reference no: EM13709587

Questions Cloud

What must be the surface area of the lift cylinder : A hydraulic lift must lift 7000 lbs using oil that is under pressure of 130 lbs/in^2. what must be the surface area of the lift cylinder?
Exceptional thermal-insulation properties : The thermal protection system for NASA's Space Shuttle Orbiter was effective due to its exceptional thermal-insulation properties. Calculate the heat flow (per square meter) across a 50-mm-thick ceramic tile with an outer surface temperature of 1200 ..
The amount of heat transfer during the whole process : 1.5 kg of air in a piston/cylinder assembly has initial temperature and pressure 27oC and 1.5 bar respectively. Then the system is heated in constant volume to 727oC (state 1-2) and then heated again constant pressure to 1227oC (state 2-3).Determine ..
Maximum tensile and compressive stress acting on the beam : If the built-up beam is subjected to an internal moment of 75 kn*m, determine the maximum tensile and compressive stress acting on the beam
Volcano has erupted-spewing stones-steam : A volcano has erupted, spewing stones, steam, and ash several thousand feet into the atmosphere. After some time, the particles begin to settle to the ground. Consider a nearly spherical ash particle that is 50 microns in diameter, falling in air who..
The standard atmosphere at sea level : Find the terminal velocity of an 8.5-inch-diameter sphere weighing 16 lbf falling through the following fluids under the action of gravity: (a) the standard atmosphere at sea level; (b) the standard atmosphere at 10,000 ft elevation above MSL; (c) wa..
Fluid flows through horizontal annular channel : A fluid flows through a horizontal annular channel between concentric tubes at a rate of 0.01 m3/s (the absolute roughness of each tube is 1.5 x 10-6 m). The channel (shown in the accompanying figure) has an inner diameter of 25 cm, an outer diameter..
Percentage of error involved in treating carbon dioxide : For an upcoming performance of the Tchaikovsky’s The Year1812, you need some very well-timed simulated cannon fire sounds, and decide to use a series of 2-liter soda bottles filled precisely with dry ice and water to go off at the right time based on..
Determine the frictional force acting on the ladder : The ladder has a uniform weight of 80 lb and rests against the smooth wall at B. If the coefficient of static friction at A is mu(a)= 0.4, determine if the ladder will slip. Take theta= 60 deg

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  A closed steel bottle contains carbon dioxide at -20

a closed steel bottle contains carbon dioxide at -20 degrees c x20 and the volume is 0.05 m3. it has a safety valve

  Find the power rating of the electric heater

find (a) the power rating of the electric heater and (b) the temperature rise that the air experiences each time it passes through the heater.

  If a system has two redundant safety systems with failure

if a system has two redundant safety systems with failure rates of 0.16 and 0.22 faults per year respectively what is

  A cylindrical graphite pure carbon rod of length 25 cm and

a cylindrical graphite pure carbon rod of length 25 cm and initial diameter of 2 cm is inserted into a flowing air

  Water flows out of a large reservoir through pipe a at a

water flows out of a large reservoir through pipe a at a rate of 15 kgs density of water 1000 kgm3 viscosity of water

  To understand the physics of the o-ring we may need to

to understand the physics of the o-ring we may need to start formulating the problem in a static equilibrium condition.

  Blended mass and starch-protein ratios

In a single screw extruder, rice starch, soy protein and water were mixed in the mass ratio of 60:35:5. The homogeneity of the mixture was assessed in terms of mixing index (MI). Ten random samples were drawn from the final blended mass, and starch-p..

  Show that the rate at which shaft work is obtained or

a. show that the rate at which shaft work is obtained or required for a reversible change of state in a closed system

  The following wind conditions are expected v 10 i - 5 j

from time t0 to t5 hr radioactive steam is released from a nuclear power plant located at x -1 mile and y 3 miles.

  The velocity of the air stream decreases from 230 ms to 30

air at 80 kpa and 127 degrees celsius enters an adiabatic diffuser steadily at a rate of 6000 kghr and leaves at 100

  A piston-cylinder containing liquid water

A piston-cylinder containing liquid water at 20 Celsius undergoes a constant pressure process at 25 bars, to a final temperature of 400 Celsius. Draw the T-v diagram. Determine the work and heat transfer for each of the three parts of the process (a)..

  Determine a the effectiveness of the regenerator b the rate

a gas refrigeration system using air as the working fluid has a pressure ratio of 5. air enters the compressor at 0

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd