Various car and truck spare parts using different steels

Assignment Help Mechanical Engineering

Reference no: EM13707417

Suppose you are appointed as a material engineer at an industry company. The company produces, cutting tools, various car and truck spare parts using different steels. The steels as raw materials to make the parts. All steels are round bars with 50 mm in diameter and 5 m long. However, when the materials were delivered to the company, for some reasons the five different types of steels were mixed up (All the labels are disappeared). Your manager asked you to sort out the mixed steels within a week. There are no chemical composition analysis facilities available. The only information you have is from the delivery documents, where it shows that the materials are pure iron, 1040 steel, 1070 steel, O1 tool steel and 4340 steel. You are asked to provide at least two techniques/methods to successfully complete your task assigned by your manager, and to explain why your techniques/methods will work.

Reference no: EM13707417

Questions Cloud

Calculate indicated mean effective pressure : A 3L, 4-stroke, V6 engine with a 9.5:1 compression ratio delivers 205 N-m at 3600 RPM. At this speed, air enters the cylinder at 85 kPa and 60 C and combustion ends at 20 crank angle after top-dead-center. It is known that the engine is square and th..

Calculate the mass of fuel injected per cylinder : A direct injection, four-stroke, six cylinder Diesel engine has 10L if displacement volume. Bore and stroke dimensions are 125mm and 136mm, respectively. The engine was designed to deliver 184 HP at 2100 RPM. Calculate the air flow rate (g/s) when pi..

What final fraction of the glasss volume is filled with air : An empty drinking glass is held upside down just above the surface of water. A scuba diver carefully takes the glass, which remains upside down, to a depth of 10.3 meters below the surface so that a sample of air is trapped in the glass. Assume that ..

Similarity and difference between trip and twip steels : Discuss the similarity and difference between TRIP and TWIP steels. Discuss the advantages of TWIP steels. Discuss the effects/roles of Mn, Al and Si in TWIP steels.

Various car and truck spare parts using different steels : Suppose you are appointed as a material engineer at an industry company. The company produces, cutting tools, various car and truck spare parts using different steels. The steels as raw materials to make the parts. All steels are round bars with 50 m..

Thin-walled cylindrical pressure vessel : A thin-walled cylindrical pressure vessel is capped at the end and is subjected to an internal pressure (p). The inside diameter of the vessel is 6 ft and the wall thickness is 1.5 inch. The vessel is made of steel with tensile yield strength and com..

Delta velocity required to change inclination of orbit : Calculate the delta velocity required to change the inclination of a circular orbit at 32,000 km altitude from a 28.5 degree inclination to an inclination of 45 degrees. Compute the propellant used if the satellite weighs 1200 lbs after the maneuver.

Design a hohmann transfer to take a satellite from a parking : Design a Hohmann transfer to take a satellite from a parking orbit 200 km by 400 km to a circular orbit with a period of 4 hours. Show all calculations

Alloy specimen is under a tensile stress test : A cylindrical S-950 alloy specimen is under a tensile stress test. The specimen is 975 mm long. If the tensile stress is 300 Mpa and temperature is at 730C. What is the total elongation after 4 hour steady state operation? Assume the total of both in..

User Account

All Pages