Uva levels in raw and treated drinking water

Assignment Help Civil Engineering
Reference no: EM1383473

My question is regarding UVA levels in raw and treated drinking water with regard to TOC and DOC removal. Is there a jar test procedure that incorporates the UVA values of the various stages of treatment and is there a document you could refer me to?

Reference no: EM1383473

Questions Cloud

Seepage velocity and estimating hydraulic gradient : The dye appears 14 days later in an observation well 75 ft away from the injection point. Compute the seepage velocity and estimate the hydraulic gradient in the aquifer if the porosity of the soil is 42%.
Tightening of bolt in the friction grip : What difference does the tightening of bolt in the friction grip joint make to the load at first slip and the failure load.
Determine the volume flow rate of water : Water with a static pressure of 1.96kN/M 2 flows through an 800 mm diameter pipe. A pitot tube pressure gage in this pipe reads a pressure of 5.88 kN/M 2 . How do you determine the volume flow rate (Q) of the water? (Q = 1.40 M^3/sec, V=2.79 M/se..
Power plant efficiency problem : A 600 MWe power plant has an efficiency of 36% with 15% of the waste heat being released to the atmosphere as stack heat and the other 85% taken away in the cooling water.
Uva levels in raw and treated drinking water : My question is regarding UVA levels in raw and treated drinking water with regard to TOC and DOC removal. Is there a jar test procedure that incorporates the UVA values of the various stages of treatment and is there a document you could refer me ..
Dissolved inorganic carbon sample : The total dissolved inorganic carbon (TIC) of a sample of groundwater is 8.33 mM. The temperature of the aquifer is 15C, the pH is 7.5, and the ionic strength is 0.05 M. What is the H2CO3, HCO3-, CO3 2-, and the partial pressure of CO2? [Use activ..
Explain the resource-based view : Explain the resource-based view and its relation to strategic management. Identify at least three ways that this view differs from the I/O view.
What is looting describe in your own words : Explain in your own words the differences between a "for-profit" and a "not-for-profit" corporation. What is "looting?" Describe in your own words.
Cause of pavement damage : On a flexible pavement with a 3 inch hot mix asphalt (HMA) wearing surface, a 6 inch soil cement base and an 8 inch crushed stone subbase, which truck will cause more pavement damage?(Suppose drainage coefficients are 1.0).

Reviews

Write a Review

Civil Engineering Questions & Answers

  Prepare a capstone report

Prepare a capstone report for designing of steel building using AISC 14 edition manual.

  Determine the stress state at points a & b

CE 3303 – Solids – MWF – Spring 2014 - Homework Set 23, – The pipe shaft of the auger, rotating at a constant angular velocity, is subject to the axial force and torque shown. Determine the stress state at points A & B and show on a stress element.

  Total vehicle delay in the cycle with queueing diagram

If the queue clears exactly at the end of the effective green D/D/1 queuing applies, determine the total vehicle delay in the cycle (in veh-sec) .

  Ratio of the magnitude in uniform electric field

What is the ratio of the magnitude of E2 to the magnitude of E1? You may neglect the effects of gravity on the proton.

  Comparative analysis of the types of safeguards

Provide a comparative analysis of the types of safeguards would you suggest for the company's information system.

  Fraction of the herbicide

The herbicide 2,4,D, is applied to a golf course at a rate of 1.2 kg/ha. The organic matter content of the soil is 1%, bulk density is 1.3 g/cm3, and water content is 0.3. a) What fraction of the herbicide is adsorbed, and what fraction is dissolve..

  Determination of edta titration

Does the presence of Mg2+ significantly interfere with the determination of Ca 2+ by the EDTA titration?

  Shear tension and bending of the fixed i-beam

To satisfy desige limitation it is necessary to determine the effect of the 2- kN tension in the cable on the shear tension and bending of the fixed I-beam.

  Effective thermal capacity in climates

For energy conservation, materials with a high thermal capacity are effective in climates in which the heat flow through the building envelope is:

  Percent by weight of limestone

A slurry containing 20 percent by weight of limestone (CaCO 3 ) is processes to separate pure dry limestone from water. If feed rate is 2000kg/h, how much CaCO 3 is produced per hour?

  Determining the pumping rate

Determine the required pumping rate. the aquifer has T= 1600 m 2 /day and the wells each have radius of influence of 600m.

  Conductive heat loss through the furnace wall

Assuming unit surface area, find the conductive heat loss through the furnace wall and the temperature at the interface of the fire clay and red brick.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd