Two-phase liquid-vapor mixture of refrigerant

Assignment Help Mechanical Engineering

Reference no: EM13704541

A tank contains a two-phase liquid-vapor mixture of Refrigerant 22 at 10 bar. The mass of saturated liquid in the tank is 25 kg and the quality is 60%. Determine the volume of the tank, in m^3, and the fraction of the total volume occupied by saturated vapor.

Reference no: EM13704541

Questions Cloud

Accounting for variation of specific heats with temperature : An air-standard Diesel cycle has a compression ratio of 18.2. Air is at 27°C and 100 kpa at the beginning of the compression process and at 1700 K at the end of the heat-addition process.

Consider an electric motor with shaft power output : Consider an electric motor with shaft power output of 20kW and an efficiency of 88%. Determine the rate at which the motor dissipates heat to the room it is in when the motor operates at full load. In winter, this room is normally heated by a 2-kW re..

Energy is required to melt cubic inch from room temperature : Given the melting point of steel to be approximately 1500 C, how much energy is required to melt a cubic inch from room temperature? How much water would this amount of energy raise by 10o C from room temperature?

Design a hollow steel shaft to transmit : Design a hollow steel shaft to transmit 225 kw of power at 80 rpm without exceeding a shearing stress of 60 MPa. Consider only torsion and assume that there are no stress concentrations. Make the ratio of the outside diameter to the inside diameter t..

Two-phase liquid-vapor mixture of refrigerant : A tank contains a two-phase liquid-vapor mixture of Refrigerant 22 at 10 bar. The mass of saturated liquid in the tank is 25 kg and the quality is 60%. Determine the volume of the tank, in m^3, and the fraction of the total volume occupied by saturat..

Air enters a gas turbine of an air-standard brayton cycle : Air enters a gas turbine of an air-standard Brayton cycle at 1000 kPa, 1000 K, and expands to 100 kPa in two stages. The air is reheated between the stages at a constant pressure of 400 kPa to 1000 K. The compressor work input is given as 250 kJ/kg.

Piston-cylinder device with set of stops initially contains : A piston-cylinder device with a set of stops initially contains 0.6kg of steam at 0.8MPa and 500Â°C. The location of the stops corresponds to 60percent of the initial volume. Now the steam is cooled. Determine the compression work of the final state ..

Assuming constant specific heat at room temperature : A Stirling cycle operates with 1 kg of air between thermal energy reservoirs at 27oC and 527oC. The maximum cycle pressure is 2000 kPa and the minimum is 100 kPa. Assuming constant specific heat at room temperature,

Sheet of epoxy reinforced : A sheet of epoxy reinforced with 60% unidirectional E-glass fibers, where x is the fiber direction. Strains ex= 0.0030, ey=-0.0020, and yxy = .0025 are measured. Estimate the applied stress ox, oy, txy

User Account

All Pages