Two cylinders are filled with liquid water 1000 kgm3 and

Assignment Help Mechanical Engineering
Reference no: EM13628005

Two cylinders are filled with liquid water, ? = 1000 kg/m3, and connected by a line with a closed valve. A has 100 kg and B has 500 kg of water, their cross-sectional areas are AA = 0.1 m2 and AB = 0.25 m2 and the height h is 1 m. Find the pressure on each side of the valve. The valve is opened and water flows to an equilibrium. Find the final pressure at the valve location.

Reference no: EM13628005

Questions Cloud

Calculate the mass flow rate of air and the required power : air is compressed by an adiabatic compressor from 100 kpa and 20 degc to 1.8 mpa and 400 degc. air enters the
Suppose that you save for retirement by contributing the : suppose that you save for retirement by contributing the same amount each month from your 25th birthday until your 65th
The air above water is cooled as a result of the water : the air above water is cooled as a result of the water absorbing heat from the air. the density of air is 1.29 kgm3 and
The plate is heated over its total length to a temperature : air at 20 kpa and 20 degc flows across a flat plate 60 cm long. the free stream velocity is 30 ms and the plate is
Two cylinders are filled with liquid water 1000 kgm3 and : two cylinders are filled with liquid water ? 1000 kgm3 and connected by a line with a closed valve. a has 100 kg and b
Fixed to the origin is a charge q -0320 nc is there a : fixed to the origin is a charge q -0.320 nc. is there a location including the effects of gravi- ty where a proton can
When you move up from the surface of the earth the : when you move up from the surface of the earth the gravitation is reduced as g 9.807 - 3.32 times 10-6 z with z as the
Helium at atmospheric pressure and 30 degc flows across a : helium at atmospheric pressure and 30 degc flows across a square plate at a free stream velocity of 15 ms. calculate
Air at 1 atm and 30 degc flows over a 15 cm square plate at : air at 1 atm and 30 degc flows over a 15 cm square plate at a velocity of 10 ms.a. calculate the maximum boundary layer

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Fnd the compressors a isentropic efficiency b second law

a adiabatic r-134a compressor has an inlet state of 100 kpa -10 degc and an exit state of 60 degc 600 kpa. the dead

  The ring is 100 m in radius how quickly must the space

engineers are trying to create artificial gravity in a ring-shaped space station by spinning it like a centrifuge. the

  The polynomial method is to be used to solve the equation

The polynomial method is to be used to solve the equation. For the graphs, Mathcad or similar program is necessary to graph the solution.

  A knoop microhardness measurement was made on a sample

a knoop microhardness measurement was made on a sample that resulted in a khn of 481when a load of 5120 kg was applied.

  Calculate the maximum mass flow rate at the inlet condition

a refrigerant 134a at 140 kpa and -10 degree celcius is compressed by an adiabatic 16kw compressor to an exit state of

  The compressor isentropic efficiency is 08 calculate the

refrigerant 410a is used for a heat pump. the temperature at the evaporator is -20f. the temperature at the exit of the

  Determine the vertical component vy of the velocity of his

a long jumper approaches his takeoff board a with a horizontal velocity of 30 ftsec. determine the vertical component

  What power could be transmitted by a similar shaft rotating

If the maximum shear stress is limited to one-half of its yield strength and the fillet radius is 0.3 in, what is the maximum torque that can be applied? What power could be transmitted by a similar shaft rotating at 400 rpm?

  Determine the initial discharge rate of water

The tank air pressure above the water level is 300kPa(absolute) while the atmospheric pressure is 100kPA. Neglecting frictional effects, determine the initial discharge rate of water from the tank.(Density of water=1000kg/m^3)

  The amount of energy required to bring the vehicle to a

consider a 1500 kg vehicle traveling at some unknown velocity and suddenly the brakes are applied and the vehicle is

  How much energy must be added to the water by heating

The water is initially at room temperature (293 K). Water boils at 373 K. How much energy must be added to the water by heating it in order for it to start boiling?

  How long will it take the puck to slow down to a speed

how long will it take the puck to slow down to a speed of 1m/s and how long will it take for the puck to stop completely? How far will the puck travel before it slows to 1m/s? You can assume the table is very very long.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd