Two blocks a and b of mass 8 kg and 12 kg respectively hang

Assignment Help Mechanical Engineering
Reference no: EM13628560

Two blocks A and B, of mass 8 kg and 12 kg respectively, hang from a cable which passes over a pulley of negligible mass. Knowing that the blocks are released from rest and that the energy dissipated by the axle friction in the pulley is 10 j,

determine (a) the velocity of block B as it strikes the ground, (b) the force exerted by the cable on each of the two blocks during the motion

Reference no: EM13628560

Questions Cloud

A body of 2kg is suspended from the ceiling of an elecator : a body of 2kg is suspended from the ceiling of an elecator moving up with an accelration g. find the apparant weight of
A body of 2kg is suspended from the ceiling of an elecator : a body of 2kg is suspended from the ceiling of an elecator moving up with an accelration g. find the apparant weight of
At a section down- stream at ground level the pipe diameter : water flows in a circular pipe. at one section the diameter is 0.3 m the static pressure is 260 kpa gage the velocity
A scaffold of mass 61 kg and length 65 m is supported in a : a scaffold of mass 61 kg and length 6.5 m is supported in a horizontal position by a vertical cable at each end. a
Two blocks a and b of mass 8 kg and 12 kg respectively hang : two blocks a and b of mass 8 kg and 12 kg respectively hang from a cable which passes over a pulley of negligible mass.
Calculate the thrust produced by the motor on a test : at rated thrust a liquid-fueled rocket motor consumes 180 lbms of nitric acid as oxidizer and 70 lbms of aniline as
Automobiles arrive at a vehicle equipment inspection : automobiles arrive at a vehicle equipment inspection station according to a poisson process with rate ? 10 per hour.
If 236 g of gold is deposited on the negative electrode of : if 23.6 g of gold is deposited on the negative electrode of an electrolytic cell in a period of 2.99 hours then what is
Determine the distanced s traveled by the 10-kg cart before : the system is released from rest with no slack in the cable and with the spring unstretched. determine the distanced s

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Steam at 95 bar and 400 c is supplied in turbine the

steam at 95 bar and 400 c is supplied in turbine. the condenser pressure is 0.035 bar. if the plant operates as a

  Steam is generated in a boiler if the initial water enters

steam is generated in a boiler. if the initial water enters the boiler as saturated water at 1000 psi a h542.4 btuibm

  Determine the fatigue strength at 5 x 105 cycles what is

the fatigue data for a brass alloy are given as followsstress amplitude mpa -----------------cycles to failure310

  A two ton 4000 ibf weight is suspended on a 30 foot long

a two ton 4000 ibf weight is suspended on a 30 foot long half inch diameter steel cable. what was the original length

  A compressor is operating in a continuous steady-state

a compressor is operating in a continuous steady-state manner to produce a gas a temperature t2 and pressure p2 from

  What is the elastic modulus of elasticity

a standard steel specimen of 13 mm diameter elongated 22 mm when it was subjected to a tensile force of 29.5 kN if the specimen has a length of 200 mm and that force applied within elastic range. what is the elastic modulus of elasticity ?

  Estimate the annual emissions of co2 and so2 from a 1500

estimate the annual emissions of co2 and so2 from a 1500 mwth steam generation plant if the boiler operates at 1800 k

  Obtain a relation for the variation of temperature in the

consider a large plane wall of thickness l0.4 m thermal conductivity k 1.8 wmmiddotdegc and surface area a 30 m2. the

  The filter passes all wavelengths between 600 and 1000 nm

a photocell is composed of germaniumand it is exposed to filtered solar radiation. the filter passes all wavelengths

  Calculate the mass in kg of oxygen that has been released

a 10 m3 oxygen tank is at 15 degree c and 800 kpa. the valve is opened and some oxygen is allowed to escape until the

  How many workers trucks and jack hammers should be assigned

a gold processor has three mines of gold ore mine a mine b and mine c. in order to keep his plant running at least 200

  Determine the power required by the compressor and the rate

air with mass flow rate of 0.4 kgs enters an insulated compressor operating at steady state.determine the power

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd