Two balls of equal mass collide-travel off in different ways

Assignment Help Physics
Reference no: EM13549737

Two balls of equal mass collide and travel off in different directions as shown. Assume the red (inicident) ball leaves at an angle of 60ofrom it's initial direction of motion and the green (originally stationary) ball leaves at an angle of 30o. (Note: The figure is not drawn to scale.) If the initial velocity of the red ball is 4.0 m/s, what is its final velocity?

Reference no: EM13549737

Questions Cloud

Explain what is the volume occupied by the liquid : We add R12 to the tank until the final mass of R12 inside the tank is 80 kg. If the temperature remains constant, what is the volume occupied by the liquid in the final state. How much mass of R12 was added to the tank
Calculate the partial pressure of each gas in the container : Three gases (8.00 of methane, , 18.0 of ethane, , and an unknown amount of propane, ) were added to the same 10.0-container. Calculate the partial pressure of each gas in the container
Explain the measured density of the hydrochloric acid : The mass of a beaker is 5.333 g. After 5.00 mL of a concentrated hydrochloric acid solution is pipetted into the beaker, the combined mass of the beaker and the hydrochloric acid sample is 11.229 g. From the data, what is the measured density of t..
What surfaces are likely to cause this friction : A 30 kg launching machine fires a 250 gram projectile horizontally at 100 m/s. This causes the machine to slide backward 1.122 meters before coming to a rest. What surfaces are likely to cause this friction
Two balls of equal mass collide-travel off in different ways : Two balls of equal mass collide and travel off in different directions as shown. Assume the red (inicident) ball leaves at an angle of 60ofrom it's initial direction of motion and the green (originally stationary) ball leaves at an angle of 30o. (Not..
A small electric immersion heater is used to boil : A small electric immersion heater is used to boil 60.0 g of water for a cup of instant coffee. The heater is labeled 165.0 W, which means that it converts electrical energy to heat at this rate. Calculate the time required to bring this water from 13..
In a single-slit diffraction experiment : In a single-slit diffraction experiment, a beam of monochromatic light of wavelength 630 nm is incident on a slit of width 0.400 mm. If the distance between the slit and the screen is 1.80 m, what are the positions of the first dark fringes?
Consider gas of neutrons in nuclear reactor : Consider a gas of neutrons in a nuclear reactor. The neutron density is 10^8 neutrons/cm^3 in an operating reactor which has a core temperature of 535K. Are the neutrons in the reactor core a classical gas or a quantum mechanical gas and how ca n yo..
Find the value of the damping coefficient : A 98.0 cm pendulum is released from a small angle. After 124 oscillations the amplitude is one half of its original value. The damping is proportional to the speed of the pendulum bob. Find the value of the damping coefficient, ?, (in Hz).

Reviews

Write a Review

Physics Questions & Answers

  Find the magnitude of the resulting magnetic field

A sphere of radius R is uniformly charged to a total charge of Q. It is made to spin about an axis that passes through its center with an angular speed ω. Find the magnitude of the resulting magnetic field at the center of the sphere.

  Find the equivalent resistance

A resistor is in the shape of a cube, with each side of resistance  R . Find the equivalent resistance between any two of its adjacent corners.

  What is the electric field at the location

Question: Field and force with three charges? What is the electric field at the location of Q1, due to  Q 2 ?

  What is the maximum displacement of the bridge deck

What is the maximum displacement of the bridge deck?

  What is the magnitude of the current in the wire

What is the magnitude of the current in the wire as a function of time?

  Blackbody

Questions on blackbody, Infra-Red Detectors & Optic Lens and Digital Image.

  Gravity conveyor

Illustrate the cause of the components accelerating from rest down the conveyor.

  Calculate the dc voltage

Calculate the dc voltage applied to the circuit.

  Quadrupole moments in the shell model

Quadrupole moments in the shell model

  Determine the tension in each string

Determine the tension in each string

  Introductory mechanics: dynamics

Calculate the smallest coefficient of static friction necessary for mass A to remain stationary.

  Evaluate maximum altitude

Evaluate maximum altitude?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd