Transmitted over the same channe

Assignment Help Electrical Engineering
Reference no: EM13686293

A telephone channel allows signal transmission in the range 600 to 3,000 Hz. The carrier frequency is taken to be 1,800 Hz.
(a) Show that 2,400 bit/s, 4PSK transmission with raised cosine shaping is possible. Show that the 6 dB bandwidth about the carrier is 1,200 Hz.
(b) 4,800 bits/s are to be transmitted over the same channel. Show that 8PSK, with 50% sinusoidal roll-off, will accommodate the desired date rate. Show that the 6 dB bandwidth about the carrier is now 1,600 Hz.

Reference no: EM13686293

Questions Cloud

Branding and packaging strategy : Outline your product, branding, and packaging strategy.
Community for sharing knowledge and working together : Community for sharing knowledge and working together
Is the product market attractive : Is the Product Market Attractive
What are the alternative methods to conduct load test : What are the alternative methods to conduct load test without alternator field winding.
Transmitted over the same channe : Transmitted over the same channe
Which markovich still would be willing to build the plant : Markovich Corporation is considering building a new plant. It will cost $1 million today to build it and it will generate revenues of $1.121 million three years from today. Of the interest rates below, which is the highest interest rate at which Mark..
Characteristics of high-performing project teams : Explain in your own words what you believe are the four most significant characteristics of high-performing project teams. Discuss why you believe each characteristic you chose is so critical
What is your average total cost : What is your average total cost? Presume you could produce one more (the fifth) widget at a marginal cost of $5. If you do produce that fifth widget, what will your average total cost be? Has your average total cost increased or decreased? Why?
Monetary policy and inflation : "Monetary Policy and Inflation" Please respond to the following: From this week’s e-Activity, examine two methods that the Federal Reserve can implement to support a stronger economic recovery. Provide support for each method in your response. Identi..

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Devise a way to address words of memory using fewer n pins

As more and more memory is squeezed onto a single chip, the numberof pins needed to address it also increases. It is often inconvenient to have large numbers of address pins on a chip. Devise a way to address 2^n words of memory using fewer than n..

  Derive sequential circuit with two inputs using d flip flops

Overlapping sequences should also be detected (ie 00->11->00->11->00 should output 0 0 0 1 0 1). Use a Moore model, and show all of your work including the state machine, state table, state assignment, state assignment table, and the final circuit..

  Design parallel resonant circuit that capacitor can adjust

Design a parallel resonant circuit so that a variable capacitor can adjust the resonant frequency over the AM broadcast band, 535 to 1605 kHz, with Q

  Determine the test pattern that detects the fault

Assume that a stuck-at-1 fault occurs at the output of the circuit ((A+B)(B+C))'. Determine the test pattern that detects the fault. Repeat for a stuck-at-0 fault at the output.

  What are the alternative methods of controlling motors

What are the advantages and disadvantages of controlling the Induction motor speed by adjusting the voltage What are the alternative methods

  The closed limb of a macleod gauge has a diameter of 1mm

the closed limb of a macleod gauge has a diameter of 1mm and a value v above the level of the opening w of 250cm3.

  Determine the displacement at time t and z

A wave is specified by y = 8cos2π(2t-0.8z), where y is expressed in micrometers and the propagation constant is given in μm-1. Find (a) the amplitude, (b) the wavelength, (c) the angular frequency, and (d) the displacement at time t=0 and z=4 μm.

  Determine value of n for diode operating at constant temp

Suppose we have a junction diode operating at a constant temperature of 300K. With a forward current of 1mA, the voltage is 600mV. Furthermore, with a current of 10mA,the voltage is 700mV. Find the value of n for this diode.

  Describe the characteristics of the series rc filter circuit

Describe the characteristics of the series RC filter circuit with the output across the resistive component. Distinguish the pass and stop bands with reference to the cutoff frequency. Also, state what happens to the circuit complex impedance at t..

  Indicate along the wire the product term it is implementing

Our third word problem case study described a logical "function unit" that computed the eight combinational functions of the inputs A and B: constant 1, A OR B, A NAND B, A XOR B, A XNOR B, A AND B, A NOR B, and constant 0.

  Determine and plot correlation sequence between two signals

Let x[n] = [1,2,3,2,1] with arrow under 3 and y[n] = [2,1,0,-1,-2] with arrow under 0. a) using scanning operation, determine and plot correlation sequence between two signals. b) Determine and plot correlation coefficient.

  Design a four-bit counterlike circuit controlled by input

Design a four-bit counterlike circuit controlled by the input w. If w=1, then the counter adds 2 to its contents, wrapping around if the count reaches 8 or 9. Thus if the present state is 8 or 9, then the next state becomes 0 or 1, respectively.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd