Total upward normal force exerted by both knife edges

Reference no: EM13562055

A meter stick weighing 150 g sits on two knife edges, one at the 20 cm mark the other at the 90 cm mark. What is the total upward normal force (in N) exerted by both knife edges?

Reference no: EM13562055

Questions Cloud

How many photons per second are hitting the wall : A beam of red laser light (? = 633 nm) hits a black wall andis fully absorbed. If this exerts a total force of F = 5.5 nNon the wall, how many photons per second are hitting the wall

Explain the final solvent production rate : Toluene (C7H8) is also added to the benzene at a rate of 213 kgmol/hr to enhance the solvent properties. Finally, it is necessary to add phenol(C6H6O) so that the final solvent production rate(mass flow rate) is 115000 kg/hr. At what mas flow rate..

Component of acceleration of portion of tape : A computer tape moves over two drums at a constant speed v0. Knowing that the normal component of the acceleration of the portion of tape in contact with drum B is 350 ft/s2, determine (a) the speed v0, (b) the normal component of the acceleration of..

Explain maximum specific activity of a purified preparation : Under certain conditions the maximum specific activity of a purified preparation of triosephosphate isomerase was quoted as 10,000μmoles glyceraldehyde 3-phosphate transformed per mg protein per minute.

Total upward normal force exerted by both knife edges : A meter stick weighing 150 g sits on two knife edges, one at the 20 cm mark the other at the 90 cm mark. What is the total upward normal force (in N) exerted by both knife edges?

Obtain the length of the wire forming the solenoid : A solenoid 1.45 m long and3.10 cm in diameter carries a currentof 21.0 A. The magnetic field insidethe solenoid is 17.0 mT. Find the length of the wire forming the solenoid

Find the speed of efflux : A small circular hole 6.90 mm diameteris cut in the side of a large water tank, 19.0 m below the water level in the tank. The topof the tank is open to the air. Find the speed of efflux

The temperature change depends on the moles of water : The temperature change depends on the moles of water produced (moles of reaction) and the mass of the solution. Assume that the density of each solution is 1.0 g/mL.

Find the rotational kinetic energy about center of gravity : A 10.0 kg cylinder rolls withoutslipping on a rough surface. At an instant when its center ofgravity has a speed of 12.0 m/s. find the rotational kinetic energy about its center of gravity

User Account

All Pages