Total extend time for drill feed is 30 seconds with

Assignment Help Mechanical Engineering

Reference no: EM13638084

Retrofit an existing clamp and drill circuit for maximum effeiciency. The cylinder that clamps the part into place is a 4 inches bore, 2 inches rod diameter, 18 inches stroke with an extended time of 1.75 seconds and a retraction time of 1 second. The customer wants a 25% reduction in the time. The clamping force must be 628 Lbs. The drill feed cylinder is a 2-1/2 inche bore, 1 inch rod diameter, 12 inches stroke which uses only the last 4 inches of stroke for drilling at system pressure. Total extend time for drill feed is 30 seconds with drilling portion of cycle being 28 seconds. the drill motor runs 800 rpm using 28 l/sec (60 cfm) at 3.4 bar (50 psi). what are the necessary Cvs for all valves?

Reference no: EM13638084

Questions Cloud

If 50 x 105 j of work is required to make the car go one : when one gallon of gasoline is burned in a car engine 1.22 x 108 j of internal energy is released. suppose that 1.05 x

The hydrolysis of methyl acetate into ch3oh and ch3cooh in : the hydrolysis of methyl acetate into ch3oh and ch3cooh in 1m hclhas been studied at 25 degrees c. the extent of

The azimuth from station a of a link traverse to an azimuth : the azimuth from station a of a link traverse to an azimuth mark is 212o 12 36. the azimuth from the last station of

Identical point charges of 30e-6c are fixed to 3 of the 4 : identical point charges of 3.0e-6c are fixed to 3 of the 4 corners of a square. what is the magnitude q of the negative

Total extend time for drill feed is 30 seconds with : retrofit an existing clamp and drill circuit for maximum effeiciency. the cylinder that clamps the part into place is a

A charge of -40 nc is at the origin and a second charge of : a charge of -4.0 nc is at the origin and a second charge of 11.0 nc is at x 5.00 m. find the magnitude and direction

If this component is subjected to the following state of : an engineering component is made of 7075-t6 aluminum that has 469 mpa in yield strength. if this component is subjected

A bending moment of 3 kn-m and a torque of 5 kn-m a safety : a solid circular shaft has a diameter of 60 mm and is subjected to a tensile axial load of 200 kn a bending moment of 3

Describe and explain two alternatives to nhst what do their : describe and explain two alternatives to nhst. what do their proponents consider to be their

User Account

All Pages