Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Obtain the power factor of a two-branch parallel circuit whre th efirst branch has Z1 = 2 + j4 ohms and the second Z2 = 6 + j0 ohms. To what value must the 6-ohm resistor be changed to result in the overall power factor of 0.90 lagging?
In a voltage stabilizer circuit with a Zener diode, the output voltage decreases when touching the zener diode with your fingers when no load is connected. Ideally, the output voltage should not drop. Explain why there is a decrease in output volt..
A diode is connected in series with a 30-V rms source to charge a 12-V battery with an internal resistance of 0.1 ohm. Specify the series resistance necessary to limit the peak current to 2A. Estimate the time required to recharge a 10-A hr batter..
A solar cell at 300K has an open circuit voltage of 0.55V and short circuit current of 2A with ideality factor of 1.3 Calculate Fill Factor and maximum power output under the following conditions: 1. Series resistance 0.08 Ohm, shunt resistance very ..
What is the magnitude of the frequency component at 30 kHz? The square wave is passed through an ideal rectangular low pass filter that completely attenuates all frequencies higher than 35 kHz. Write down an equation for the spectrum at the output ..
A collector modulated transmitter has a supply voltage of 48 V and an average collector current of 600 mA. What is the input power to the transmitter How much modulating signal power is needed to produce 100 percent modulation
The magnitude of the current in a RL circuit decreases at a rate of 2000 A/s at t=0 and 100 A/s at t=.2s. At what time has the energy stored in the inductor decreased 1 percent of its intial value.
A cell phone transmits voice signals on a carrier. the transmissions lie inbetween 900MHz to 900.03MHz. What minimum sampling rate should be choosen so that the transmisions will be recoverable from the digital samles
A single phase transformer has the following rating: 120 kVA, 2000 V/100 V, 60 Hz with 1000 primary turns. Determine (A) the maximum flux. (B) given a maximum flux density of 0.25 T, the cross-sectional area of the core.
Discuss these possible reasons, indicating which are the most important: The field is so young; such different needs; there are so many types of systems; and people with widely different backgrounds are developing.
Finding values of a composite discrete time signal, A discrete time signal x(n) = x(n-1) + x(n-3) with initial conditions x(0) = 0, x(1) = 1 and x(2) = 2 is examined and the first 51
Discuss how you could build a microwave power amplifier with a power rating of 1kW with microwave power transistors with an upper power limit of 100W each. Explain how the speed of an aircraft can be measured by using pulse radar techniques.
An ideal p-n junction diode has saturation current Is = 3e-15 A. Calculate the diode current.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd