To verify the constant of a particular prism

Reference no: EM13534540

To verify the constant of a particular prism, a straight line EFGis laid out. The EDM instrument is first set up at E, with thefollowing measurements recorded: EG= 566.11m, EF=238.778 and FG=327.963m, Determine the Prism Constant.

Show steps

Reference no: EM13534540

Questions Cloud

What is the pressure at the leading edge : When an airplane is flying 200mph at 5000-ft altitude in standardatmosphere, the air velocity at a certain point on the wing is 273mph relative to the airplane. What suction pressure is developed onthe wing at that point? What is the pressure at the ..

What weight can it bear before being broken : A concrete sidewalk slab is 17.5 MPa, 4 inches deep, and 2 m long. A tree root has pushed it up so there is a 1 inch lip at the junction with the adjacent slab, and the slab is effectively 1 inch above its base underneath

Current magnetic bearing of the same line : Given an azimuth of 251 degrees 11' 23" for line ED. If theangle at DEO is 197 degrees 26' 12" measured clockwise, what is theazimuth and bearing of line EO?

What is the distance required to bring the train to a stop : The subway train is traveling at a speed of 54 km/hrwhen the brakes are fully applied on the wheels of cars B and C,causing them to slide on the track, but are not applied on car A.μ of kinetic friction= 0.35.

To verify the constant of a particular prism : To verify the constant of a particular prism, a straight line EFGis laid out. The EDM instrument is first set up at E, with thefollowing measurements recorded: EG= 566.11m, EF=238.778 and FG=327.963m, Determine the Prism Constant.

Determine the ground clearance of an overhead : Determine the ground clearance of an overhead electrical cable.surveyor B is positioned directly under the cable(surveyor B's position can be checked by his sighting past thesting of a plumb bob,held in his outstreched hand

Determine analytically whether or not it is linear : To prove that a system islinear or time-invariant, the property must be demonstrated for all possible input/output pairsand all delays. On the other hand, to prove that a system is not linear or not time-variant,the property can be demonstrated with ..

Determine the prism constant : A 100 ft cut steel tape was used to check the layout of a building wall. the rear surveyor held 42 ft while the head surveyor cut 0.33 ft. what is the distance measured?

How much must the temperature of the ring be increased : A steel ring of internal radius 499.8 mm is to be shrink-fitat normal (room) temperature over a rigid cylinder of radium r =500 mm

User Account

All Pages