Tire depends on the temperature of the air in the tire

Assignment Help Mechanical Engineering

Reference no: EM13707393

The pressure in a tire depends on the temperature of the air in the tire. The gage pressure of an automobile tire with a volume of 0.025 m3 is measured to be 210 kPa at 25 oC at sea level on a day with calm weather. If the temperature of the air in the tire drops to 10^oC: a. What is the (absolute) pressure (in kPa) inside the tire at 10 Â°C? b. How much air (in kg) needs to be added to restore the pressure to a gage pressure of 210 kPa?

Reference no: EM13707393

Questions Cloud

Determine the heat transferred to and the work produced : Steam at 75 kPa and 13 percent quality is contained in a spring-loaded piston-cylinder device, as shown in the figure, with an initial volume of 5.28 m^3. Steam is now heated until its volume is 13.20 m^3 and its pressure is 300 kPa. Determine the he..

What equivalence ratio for octane-air mixtures : At what equivalence ratio for octane-air mixtures does the carbon to oxygen ratio of the system equal one? Why is this of interest?

Maximum shearing stress in cylinder after-internal pressure : A laminated thick-walled cylinder was fabricated by shrinking a steel (E=200 GPa and nu=0.03) sleeve having an inside diameter of 199.800mm and an outside diameter of 300mm onto a steel tube with an inside diameter of 100mm and an outside diameter of..

Compare inlet steam mass and volume flow rates in pound mass : Compare the inlet steam mass and volume flow rates in pound mass per second and cubic feet per second of (a) a fossil-fuel power plant turbine having a polytropic efficiency of 0.90 and receiving steam at 2400 PSIA and 1000F and (b) a nuclear power p..

Tire depends on the temperature of the air in the tire : The pressure in a tire depends on the temperature of the air in the tire. The gage pressure of an automobile tire with a volume of 0.025 m3 is measured to be 210 kPa at 25 oC at sea level on a day with calm weather. If the temperature of the air in t..

The mass flow rate of the air and exit velocity of the air : Air enters an 8” diameter pipe at atmospheric pressure at a velocity of 30 ft/s and 65 F and exits at approximately the same pressure. While in the pipe, the air passes over a heat exchanger that causes its temperature to increase by 25 F.

The initial interference required to produce : A laminated steel (E=200 GPa and nu=0.3) cylinder consists of a jacket with an inside diameter of 250mm and an outside diameter of 300mm shrunk onto a tube with an inside diameter of 150mm. The initial shrinkage pressure is 28MPa.

Energy balance-property tables and phase changes : Energy balance, property tables, phase changes. Consider water in a pot on an alien planet. You will the pot with 1.002 L (.001002 m3) of water initially at 20°C and 75 kPa (their atmospheric pressure is different than ours). How much mass is in the ..

Two well-insulated tanks filled with carbon monoxide : Two well-insulated tanks filled with carbon monoxide (CO) gas are connected by a valve. In tank A, 1 kg of gas is stored at 100 kPa and 300 K. In tank B, 5 kg of gas are stored at 500 kPa and 870 K. The valve is opened, and the contents of the two ta..

User Account

All Pages