Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Determine the moment at B and draw the moment diagram for each member of the frame. Assume the supports at A and C are fixed and B is a fixed joint. The frame is is an upside down L shape where it goes up 6 meters and to the right 5 meters. The vertical component is member AB and the horizontal component is member BC. So, B is the corner of the L. On member BC there is a uniform distributed load of 10 kN/m. This has to be solved using the Slope Deflection Method for Frames.
A left-turn movement has a maximum arrival rate of 200 veh/h. The saturation flow of this movement is 1400 veh/h. For this approach, the yellow time is 4 seconds, all red time is 2 seconds and total lost time is 3 seconds.
The dynamic viscosity of water at 20°C is 1.00 x 10-3 N-s/m2, and the viscosity at 40°C is 6.53 x 10-4 N-s/m2. Estimate the viscosity at 30°C.
State the full name of the section of SOLAS that sets out the minimum standards for the training and competence of crew members and describe how the surveyor would go about checking that a vessel had the necessary number of qualified staff.
Determine the energy loss due to the gradual enlargement from a 25 mm pipe to a 75 mm pipe when the velocity of flow is 3 m/s in the smaller pipe and the cone angle of enlargement is 20°C.
A cube has side dimensions of 18.00 in. It is made of steel having a specific weight of 491 pcf. What force is required to hold it in equilibrium under mercury
a force is specified by the vector F=160i+80j-120k N.calculate the angles made by F with the postive x y and z axes.
a newly designed car has a 9.2 ft wheelbase, is rear wheel drive, and has a center of gravity 18 inches above the the road and 4.3 ft behind the front axle. the car weighs 2450 lb, the mechanical effciency of the drivetrain is 90%, and the wheel r..
a cylindrical specimen of a metal alloyed in stressed in compression. If its original and final diameters are 40.00 and 40.10 mm, respectively , and its final length is 120.00 mm, compute its original length(L0)
A beam of w16 X 50 section has a simple span of 20 ft. The beam is subjected to a uniform load of 2 kips/ft and an axial tensile force of 10 kips. Determine the maximum tensile and compressive stresses in the beam
A larger-diameter pipeline will cost $2.1 million installed, but its operating cost will be only $8000 per month. Which pipe size is more economical at an interest rate of 1% per month on the basis of an annual worth analysis
A civil engineering student contends that 60 mph is safe in a van because of the higher driver's eye height. If all other design inputs are standard, what must the driver's eye height in the van be for the student's claim to be valid
A 24-in.-wide by 0.100-in.-thick by 140-in.-long steel sheet is to be formed into a hollow section by being bent through 360° and having the long edges welded (i.e., butt-welded) together. Assume a cross-sectional medial length of 24 in.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd